Electronics Forum | Sun May 01 19:47:23 EDT 2016 | jasltd
Hi there, we have recently bought 2 2nd hand DEK printers & both are coming with chillers. Does any one have any info on setting them up & what they have used to fill them? Don't think they are coming with Manuals so any hints on getting one of thos
Electronics Forum | Thu Dec 23 22:31:47 EST 1999 | Vincent Chen
Hi!Charlie, 1.Are you retrofitting your spray fluxer in your wave soldering machine? If you are, please ensure that you have a air knife just before the preheater!Fluxe fumes tends to accumulate and that could be dangerous if your air exhaust is not
Electronics Forum | Mon Oct 13 13:24:21 EDT 2014 | rgduval
Deni, Yep, we found that one the other day, too. And, yes, axis mounted is set to 1. We tried setting it to 0, saving, then back to 1 (again, hoping to clear a software flag/fault, if that's what it is). Thanks, ..rob
Electronics Forum | Mon Mar 16 12:44:36 EDT 2015 | proy
soldering a very simple board in a very simple Accuheat oven. Can anyone give me basic starting point settings (conveyor speed and temperature) then we will profile using a mole from there. Paste 1) Tin Lead Paste 2) Chipquik low temp TL 165C PR
Electronics Forum | Mon Oct 20 14:56:51 EDT 2014 | rgduval
Progress!! Somehow, this morning I was able to get things almost working. I swapped cards 1 and 2 back, and then back again, so, in the same state as my last reply...set the default settings for the axes configuration...then, verified the addresses
Electronics Forum | Tue Feb 28 13:46:28 EST 2006 | slthomas
Assuming you're using DOM and shelf life to determine what's good and what's not, you just have to know 1)the rate at which you use it up, 2) how much shelf life is left, and 3) the rate that it goes bad when not refrigerated. From that you can tel
Electronics Forum | Tue Oct 14 16:13:47 EDT 2014 | dilogic
Just be careful to set the jumpers accordingly, if you swap the boards!
Electronics Forum | Mon Oct 13 18:15:38 EDT 2014 | ilavu
Hey rob, make sure you do the changer setup. That procedure looks at the fiducials on the changer and adjust the position for nozzle change. It is in system setting. Motor or amp is not easily go bad. I have machine from 92 and never had problem with
Electronics Forum | Mon Oct 13 15:33:36 EDT 2014 | rgduval
So...today, we were able to get rid of the z axis not mounted error. It looks like we did so by modifying the settings in axes location (matched them to the beam 1 settings). Now, when we try to lower the nozzles, we can hear a relay or switch clic
Electronics Forum | Mon Oct 20 10:08:42 EDT 2014 | rgduval
Had someone in from the broker that we bought this machine from, and he did some poking around. We've learned some things, but, unfortunately, are still no closer to getting the machine running :( We discovered (based on double checking other machi
