7 2-models results

Electronics Forum: 2-models (Page 1 of 1)

BGA non wetting

Electronics Forum | Tue Sep 14 02:12:22 EDT 2010 | genesan

Hi Sir, Thanks for reply and base on our system the same part are using for 2 model only and the problem occur on both assembly.By the way as feedback it happen on random pin of this BGA only.

unknown nozzle st 17

Electronics Forum | Sun Nov 17 10:50:11 EST 2013 | sara_npi

Hi, I have difficulty on solving unknown nozzle st 17.situation goes like this,almost I run bout 6 models each day,but 1 to 2 models only have this problem.I almost done a few basic troubshoot such as clean censor st 17,clean cluch using prope

unknown nozzle st 17

Electronics Forum | Tue Nov 19 12:34:33 EST 2013 | jimmyboz

I am not trying to be critical but, you didn't even say Fuji CP-6 problem. There are CP-6, CP-642, and CP-643 machines, are asking 2 model as 642? Anyway, slow the cam speed down in the proper to 40 or 50%. If the problem goes away check the mainte

BGA ball crack at pad/solder ball interface

Electronics Forum | Wed Nov 29 00:43:45 EST 2006 | callckq

Dear all, Recently, we run 2 models with heat sink attachment on top of this BGA(on top of this BGA, there is flip chip attached at the center of the BGA). Hence, the center of the BGA is higher than corner/side. We used conventional way to attach

Mydata My100 or Siemens D1?

Electronics Forum | Mon Jan 25 00:56:38 EST 2010 | sparrow

Hello, Mydata p&p machines are built for high mixed and low/mid volume production, so if you talk about very low volume - no doubt, mydata is what you can use. You can consider 2 models for your application - MY100SX or MY100LX, depending on the min

Re: Ultrasonic stencil cleaner

Electronics Forum | Mon Apr 13 19:43:32 EDT 1998 | Steve Gregory

| Could someone point me in the direction of or have any info on a basic no frills Ultrasonic cleaner capable of cleaning 20"x20" stencils? | Thanks, | Jack LaRue | jlarue@mail.nortechsys.com Hi Jack! Well, I'm sure you've heard of Smart Sonic..