Electronics Forum | Sun Jul 05 22:21:58 EDT 2020 | raoult
Hi, The micro switch is broken on my device, it was a tactile one (4mm) : image1, image2 Do you think I can buy another one and just solder it like this with 2 wires (I can't solder it back to where it was because it's too tiny I don't have the sk
Electronics Forum | Sun Jan 27 11:28:42 EST 2013 | mdang
Could anyone help to connect a FUJI CP42 machine to a conveyer with stanard SMEMA? CP42 has 2 wire cable and small female connector label SMEMA (Not fit with stanard SMEMA). Thank you for all your help, -Michael
Electronics Forum | Fri Aug 07 13:29:53 EDT 2009 | cadone
Hi, We are designing a PCB where I need a Low height wire to board connector at the edge. I am looking for a 2 wire female surface mount connector that is not taller than 2.5mm Can any one here suggest me a place I can find this. Thanks CADone
Electronics Forum | Wed May 19 20:24:09 EDT 2021 | kumarb
Thank you Michal. Very much appreciated. We are thinking along the same lines. However, we are being very afraid to even cut the official wire ties that are securing the head 1 and head 2 wiring. We have a new VAC2 solenoid in transit that will arr
Electronics Forum | Thu Dec 22 11:18:59 EST 2022 | emanuel
I am interested to know if you solved this problem. We are experiencing something similar. The table is the first node in the CAN chain. As I see the structure, the CAN starts from the Nextmove ES card, goes first to the table driver and continues to
| 1 |
