Electronics Forum | Wed May 23 16:04:43 EDT 2007 | adlsmt
Does anyone have a version of software later than 2.04e_ps? SCS/Speedline will not supply it because the computer is no longer supported. Also, the laser pointer and the auto rail width seem to have removed themselves as options. Anyone know the mast
Electronics Forum | Wed Feb 22 16:55:04 EST 2006 | mark
Hi, We are not using vaccum caps. The support pins for both printers is the same ande cover all board (components only on Top side of the PCB). I will check snap-off (right know setting 0.2-04. mm/s). I also suspected poor gasketing but clamps are o
Electronics Forum | Thu Jun 29 17:55:05 EDT 2017 | anilbasra
I have a SCS-4398 coating machine software ver:2.04E. This morning when the operator starter the machine instead of reaching out to its Home position the spray head started to hit the opposite end several times in small cyclic distance. Screen is di
Electronics Forum | Sat Jun 11 07:58:17 EDT 2016 | davef
IPC-2252 - Design Guide for RF/Microwave Circuit Boards IPC-2251 - Design Guide for the Packaging of High Speed Electronic Circuits IPC-2141A - Design Guide for High-Speed Controlled Impedance Circuit Boards IPC design standards https://portal.ip
Electronics Forum | Fri Oct 03 09:00:18 EDT 2003 | davef
EIA standard packages have a variety of L/W proportions. EIA||Dimension mm (LXW)||Proportion (L/W) 0201||0.6X0.3||2 0202||0.5X0.5||1 0303||0.8X0.8||1 0402||1.0X0.5||2 0504||1.25X1.0||1.25 ||1.4X1.4||1 0603||1.6X0.8||2 0805||2.0X1.25||1.6 1111||2.8X2
| 1 |
