Electronics Forum | Fri Jul 09 17:52:43 EDT 2021 | glasscake
Hello, I have a Topaz-X that is losing its R origin as it runs. The issue can be seen in the following test: Set the machine to ignore vacuum/ignore alignment and have no feeders in the machine also set the nozzles all to fixed. I run a servo orig
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Fri Apr 12 16:13:36 EDT 2002 | pjc
Dave, USI makes spray fluxers with stepper motor and servo motor controlled traverse heads that only spray on the board. Virtually no waste going up the stack. www.ultraspray.com
Electronics Forum | Thu Oct 26 15:53:08 EDT 2006 | fabio
I'm having a eletrical problem in my SIPLACE HS50. all the servo boards are off, when i measure the "200V" i'm having nothing but a headache... please help me.
Electronics Forum | Mon Oct 15 12:13:00 EDT 2012 | lkavan
Hallo friends, I am looking for interface board for Tenryu MT5530. Its name is DIF3-1. If you want, I can offer servo drivers or some pneumatic feeders for change. Thank you for help.
Electronics Forum | Fri Jan 05 12:02:28 EST 2018 | ilavu
Camera works fine from home to ref. position to fiducial1 and 2. Problem shows up from home to board stop. AC voltage between AC1 and AC2 is 41.7 and during move it drops to 41.5.
Electronics Forum | Thu May 16 08:58:23 EDT 2019 | tsvetan
You are lucky, out of 4 machines we have 2 failed withing first year. One has Panasonic X-axe servo driver burned. The other machine has the ASIC board burned. Nothing that can't be repaired, but still annoying as we had to wait 1 month for replaceme
Electronics Forum | Sun Sep 18 06:31:23 EDT 2022 | dilogic
It can also be a faulty servo controller (not the amplifier), I think it's UMC3 board in slot 10
Electronics Forum | Wed Jul 21 14:57:57 EDT 2004 | Steve
I have some servo driver boards that intermittantly fail and would like some information on getting them repaired. Do any of the members know of a 3rd party repair facility that can repair/exchange these boards? As not having a schematic for these so
Electronics Forum | Wed Feb 06 00:43:37 EST 2008 | jmelson
Well, as usual, you can't trust ANY documentation to get it right! I have a CSM84, model PA1306/20, the last model with DC brush motors. I have the service manual for the machine, it has schematics of much of the machine, but skips the servo amps a