Electronics Forum: 2.juki 2feeder calibration (Page 1 of 1)

Quad QSP-2 FeederBase calibration drifting

Electronics Forum | Wed Jun 19 10:49:00 EDT 2019 | jamesn

Thanks Bob for the speedy reply I will check these out and let you know Kind Regards James

Quad QSP-2 FeederBase calibration drifting

Electronics Forum | Wed Jun 19 10:11:59 EDT 2019 | jamesn

Hi to everyone I hope someone can help me with a problem I have on a Quad QSP-2. when calibrating ( Or trying to use ) Feeder Bases 2 and 4 on gantry 2 Im getting small amounts of accumulative drift in the X axis. I have changed the servo amplifier

Quad QSP-2 FeederBase calibration drifting

Electronics Forum | Wed Jun 19 10:40:07 EDT 2019 | bobpan

The only thing left is the read head. Older read heads tend to 'weaken' with age. Sometimes some engineers will shim them up closer to the scale using a 10 mil shim. You could also swap them between gantries...i dont think they are to tough to get to

Feeder Calibration and Repair Station

Electronics Forum | Wed Jun 13 10:29:54 EDT 2012 | markhoch

Is anybody using the Argos Systems FVS2 FeederVision Station? It's half the cost of the ASM (Siemens) system, and appears to do more.

Calibration of feeders

Electronics Forum | Tue Aug 17 08:36:01 EDT 2004 | rlackey

CP6/7 feeders are mechanical indexing machines, and the springs, cams etc wear over time leading to misfeeds & increased attrition. You can just strip & repair but especially on the 8x2 feeders the pick up position is critical. John, I'd check with

0201

Electronics Forum | Fri Feb 22 13:24:24 EST 2008 | mulder0990

How did I know senior was going to get in here too. Nice to see you again. I figured as much with the height difference, but I do not have the equipment here to test my thoughts. We somehow have our machine dialed in to run the 0201 parts with W

  1  

2.juki 2feeder calibration searches for Companies, Equipment, Machines, Suppliers & Information