Electronics Forum | Wed Mar 03 08:31:25 EST 2004 | pjc
Yes, considering the cost to upgrade if the Cognex 2000 goes down.
Electronics Forum | Wed Mar 03 08:57:23 EST 2004 | jpa
Then I certainly will inquire, Thanks!
Electronics Forum | Wed Mar 03 07:08:44 EST 2004 | jpa
Does anyone have an opinion, good or bad, regarding the mpm ap24x? I've only ever done manual printing and have little clue about automated printers. I'm pretty new to this whole arena and any suggestions would be much appreciated.
Electronics Forum | Wed Mar 03 07:26:16 EST 2004 | pjc
AP24X is old model. Some parts are getting hard to come by. Check if the vision system is Cognex 2000 or 5000 and what the computer is. It may have been upgraded. Otherwise, its a good printer.
Electronics Forum | Mon Apr 13 14:04:49 EDT 2015 | capse
Juki GL-1.... Any thoughts? I'm New to the > industry and I'm trying to buy a new screen > printer. I have two in mind, DEK and Juki. Up front qualifier, I'm the EKRA Rep for the southeastern US. I have been involved with stencil printers for abo
Electronics Forum | Tue Apr 21 02:28:54 EDT 2015 | dinhhuunam
Juki GL-1.... Any thoughts? I'm New to the > industry and I'm trying to buy a new screen > printer. I have two in mind, DEK and Juki. Hi Sir, I'll advise you the SJ INNOTECH Vision Screen printer Best Solution & Service for You Model HP-520S Hi
Electronics Forum | Tue Mar 02 17:26:24 EST 2004 | pjc
I worked on MicroFlex. All axis move via electric motor drive. Carraige reapatability is +/- 0.0005" (12 micron). Cameras position more easily on linear bearings than the swivel type. The alignment accuracy and repeatability easily supports sub-20mil
Electronics Forum | Fri Oct 25 14:46:50 EDT 2002 | russ
Leading edge, This is used to determine the orientation of the board as you want to run it. If you use center justified stencils this is usually not an issue since you can just turn the stencil any which way you want to. If you are using front/rear
Electronics Forum | Fri Oct 14 19:41:06 EDT 2005 | KT
We encounter this kind of issue. We use stencil clean in the stencil printer and also use air to blow aperture after cleaning. We are having some luck !!
Electronics Forum | Fri Feb 05 02:40:40 EST 2021 | victorzubashev
For components with the large pads, you can also use secondary soldering dispensing. Some printers like DEK have an option to mount a syringe with an auger valve to do dispensing after the printing step process. Obviously will not work if you have to
