Electronics Forum | Thu Apr 09 14:02:29 EDT 1998 | Earl Moon
| | I am currently involved in a reliability project related to SMT QFP and TSSOP fine pitch solder joint reliability. I have decided to use a temp chamber for stress testing. Is there a test standard that covers this? I am also a bit unsre as to whe
Electronics Forum | Fri Apr 10 20:27:07 EDT 1998 | Jean-Paul Clech
| I am currently involved in a reliability project related to SMT QFP and TSSOP fine pitch solder joint reliability. I have decided to use a temp chamber for stress testing. Is there a test standard that covers this? I am also a bit unsre as to wheth
Electronics Forum | Wed Dec 31 10:09:27 EST 1997 | Ken Daniels
| Has anyone had any experience with thermal shocking | and cracking of SMD capacitors during the rework process? | My company was advised to preheat capacitors to 125 C | at a rate of 2 C/sec before replacing them onto boards. | Would this maybe
Electronics Forum | Tue Apr 13 08:21:05 EDT 2010 | esca
Hi manchella, After ATC test, two different failure modes can be present: solder FATIGUE (into bulk) or BRITTLE INTERMETALLIC fracture. So, first you have to verify this. Moreover, which brand of SMT paste have you used ? The crack into solder joint
Electronics Forum | Fri Jun 18 17:36:10 EDT 2010 | sid
Good afternoon all, I have been trying to find a solution to a defect I just noticed. After stencil printing and smt part placement on the secondary side of my boards, I run them through a wave soldering system. All my components got soldered perfe
Electronics Forum | Tue Nov 18 11:35:43 EST 2003 | John
Does IPC list a specification that describes the acceptable thermal stress capabililty of components? I seem to recall something about dipping at 260C for 10 seconds, but I can't find the reference. Also seem to remember descriptions of the allowab
Electronics Forum | Fri Dec 30 11:54:53 EST 2005 | John S.
Seen cap cracking before. It can be caused by thermal stress as noted above, but don't discount mechanical stress and handling. Your depanelization method is a strong candidate. We applied strain gages to baords and benchmarked various mechanical
Electronics Forum | Sat Jan 16 02:43:21 EST 1999 | Earl Moon
| Hello, | | We are qualifying new sources of PWB vendors. We've got the first lot of "produciton" boards in and we want to put them through the paces before turing the vendors on. | | So far, the tests I can think of performing, and that we have
Electronics Forum | Wed Jun 23 13:56:56 EDT 1999 | Stan Frul
Hi Could anyone tell me where i can find information, in the literature or on the Web, concerning measurements of temperature distribution, expansion, stresses in the substrate and heat sink and on the interface between them, that is all the range of
Electronics Forum | Thu Jun 06 12:54:23 EDT 2013 | emeto
I think that you will be fine. You don't want to crack the part during it's stay on a high temperature in the reflow oven(thermal shock...thermal stress...). Once you mount the part on the board it will collect moisture again, but it is already proce
