Electronics Forum | Thu Nov 30 21:52:54 EST 2006 | Tim Gravit
u need 2 use dek printer
Electronics Forum | Thu Jun 01 21:43:43 EDT 2000 | Dave F
Hey Ashok: On your questions ... 1 If you measure those things, then you should be recording your efforts. Think of that stuff as calibratable equipment. 2 Use the covers My2�
Electronics Forum | Mon Jun 08 19:29:53 EDT 1998 | Eric Jenkins
Looking for used 2 used peel force testers, and used SMT parts counters also. Please call me 1 801-956-0897 or email. Eric Jenkins
Electronics Forum | Thu Oct 02 09:35:42 EDT 2008 | msangabriel
I have one brand new UV oven and 2 used ones. We used to cure Dymax conformal coating in this plant. We are selling those ovens.
Electronics Forum | Thu Apr 28 03:03:28 EDT 2011 | Jacki
Hi All I received some advice 1) use Flux with Thinner 2) use Flux with Water. Which one is better for my wave sodlering? The type of Flux is watersoluble.
Electronics Forum | Fri Dec 28 13:01:24 EST 2012 | emeto
I assume your problem is comming from the carrier. If it is so: 1. use carrier from another ,aterial 2. Use solder paste that handles faster profile Good luck!
Electronics Forum | Fri Dec 28 13:01:46 EST 2012 | emeto
I assume your problem is comming from the carrier. If it is so: 1. use carrier from another material 2. Use solder paste that handles faster profile Good luck!
Electronics Forum | Sun Sep 27 22:39:55 EDT 2009 | rajeshwara
The same issue i faced 2 yrs before , i sugest 1. Use stencil of 4 mils ( Take care of Aspect Ratio and Area Ratio ). 2. Use Solder Paste of Type 4.5 and Viscosity in between 1100 to 1300. ( Try Solder Paste of Cookson or Alpha metals : OM338 T45-L
Electronics Forum | Wed Apr 28 08:08:45 EDT 1999 | Dave F
| Can someone please supply me with a footprint for a SOT 426-L, or at least point in me the direction of where I could find one. | | Clint two sources for ya: 1 Check with your component supplier 2 Use the following link Good luck Dave F
Electronics Forum | Mon May 19 02:59:04 EDT 2003 | emeto
Hi, I can give you a few steps. 1. The solder paste. Take the profile that manifacturer gives for the paste. 2. Use termocouple to measure the tempereture. Put PCB and measure the temperature in equal terms. 3. Compare your profile to manifacturers
.gif)
