Electronics Forum | Tue Nov 21 15:49:01 EST 2000 | CAL
Dave- this may not be much current help but for future needs: IPC-7525 Stencil Design Guidelines is due out real soon. Check with IPC on its status, last I heard it was in interim Final.What is nice about this Doccument is that it also covers Pin_Thr
Electronics Forum | Thu Nov 16 16:20:23 EST 2000 | bkringen
We are a manufacturing facility of ruggedized offroad electronic control systems. We are looking for industry standards/benchmarks we can use to compare with other manufacturers with regards to our DPMO rate for our SMT process. We would like to kno
Electronics Forum | Wed Nov 15 16:14:02 EST 2000 | Scott Welle
We are having non-wet (head in pillow) problems with Altera 484's similar to the problems discussed on 10/27 timeframe. Need contacts to those people having similar problems. Will those who had problems with Motorola 357 (ref Chris and Glenn on 10/
Electronics Forum | Mon Nov 20 05:45:39 EST 2000 | Daniel Carlsson
Hi! Some varibles that I would think increase the risk: -The use of Nitrogen when soldering. -The use of IR may cause thermal vias (if placed only on one "side") to produce uneven heat distribution and thus wick the comp. -Uneven heat distribution.
Electronics Forum | Tue Nov 14 16:06:27 EST 2000 | zorox
We have an ERSA machine here where we have solder "spikes" occasionally. We have made sure our flux is dispensing properly, we have adjusted z axis speeds, our preheater is heating properly, adjusted XY speeds, etc. Can anyone think of something we m
Electronics Forum | Tue Nov 14 23:49:37 EST 2000 | DL
Our land patterns are slightly bigger than the part, we've had no problems. There are your own concerns about the part hanging over the pads, this can be ok or not depending on your application and/or how much part is over. I'm sure this is in the J-
Electronics Forum | Mon Nov 13 13:16:12 EST 2000 | Sal
Guys Has anyone had good or bad experiences with the ECD Oven/Wave rider piece of kit ? Before I ask my manager to break the bank to pay for this kit what I would like to know is what will it do for me ? but more importantly will it give the custome
Electronics Forum | Mon Nov 13 20:55:11 EST 2000 | Dave F
Not too much to go on, bud. Tell us about: * Wire material, finish, insultation, etc * Wetting problem description * Why feed that the wire is used for through is important * Range and extent of the problem * Results of metallographic analysis of "g
Electronics Forum | Sat Nov 11 10:20:10 EST 2000 | JAX
Have you tried running a glass plate? If you still need to adjust placement it is a machine issue.( calibration ) If everything is good your conversion software needs looked at. That's all I have without knowing the CAD software and Machines
Electronics Forum | Fri Nov 10 17:53:25 EST 2000 | Dave F
As fortune might have it, many CAD mfgrs use .pcb for their files. Just for a few: Zuken Visula, Pads Power-PCB, ACT CAM-350 and derivatives. Why not: * Read it into your present CAD system [assuming it's one that can read .pcb files] * Generate