Electronics Forum | Tue Oct 09 11:42:42 EDT 2012 | cyber_wolf
Actually the correct way to fix this is to carefully remove the belt on the rear of the machine that connects the left and right rail lead screws together. Square the rails then carefully re-install the belt *without turning either of the lead screws
Electronics Forum | Tue Jul 13 07:19:56 EDT 2004 | pjc
The Sentry 2000 does not have its own board handling system. It fits over an existing conveyor in your line right after the printer. You can have the conveyor R-L or L-R.
Electronics Forum | Sun Jan 09 07:10:13 EST 2011 | darlur
Hello, I got a little problem. I didn't use my OK BGA 2000 for a quite long time and I lost the software for it. Does anyone know where can I get it?
Electronics Forum | Mon Feb 20 18:39:11 EST 2006 | Aaron Zanchez
looking for ok industries nozzles
Electronics Forum | Mon Jul 12 10:14:32 EDT 2004 | tigerlordgm
I am working as part of a team to set up a new automated SMT line, with the idea being to keep it as hands off as possible. As part of this, one member of the team has purchased a used Cyberoptics Sentry 2000, which hasn't arrived yet. Since Cyberopt
Electronics Forum | Mon Dec 04 16:35:48 EST 2000 | Steve Thomas
Anyone have a source for nozzles for this system? I know that Metcal bought OK Industries, and I've also been informed that Metcal sold the line to someone else, but I don't know who it was. Any clues guys? Maybe it's not worth pursuing? I've bee
Electronics Forum | Tue Aug 04 09:02:34 EDT 2009 | kpm135
We replaced the tactile sensor's linear actuator on a MPM Ultraprint 2000 HiE. Now we are getting a Tactile Hardware limit error every time we try to find the stencil height. I was hoping some one could explain why we're getting this error and any i
Electronics Forum | Thu Apr 14 16:48:56 EDT 2005 | bandjwet
Does anyone have experience with older laminographic 4PI XRAY systems? Does anyone know if these are still being serviced? Regards Bob Wettermann BEST
Electronics Forum | Tue Aug 04 13:44:05 EDT 2009 | swag
Check your DIP switch settings on new driver. Not sure about calibration. Try QMPM for password.
Electronics Forum | Tue Aug 04 14:43:12 EDT 2009 | kpm135
Thank you very much SWAG that password did the trick. Got us into the calibration menu and we were able to calibrate the z-axis and snugger height and got it to work. Thanks again