Electronics Forum | Tue Nov 08 10:52:29 EST 2016 | aemery
Tom, Hardware limit means the machine thinks it is at the limit sensor or a particular axis timed out before it got to the home sensor during the reset sequence. Go to your O/I map and see if any of the axis limit sensors are lit. You could have a
Electronics Forum | Tue Aug 15 02:45:14 EDT 2006 | dman97
Does anyone know if it is possible to lower the camera brightness when selecting fiducials? Our UP2020's camera is extremely bright and sometimes it causes the fiducials to be rejected cause they are too bright to be seen. Any settings than can be a
Electronics Forum | Tue Nov 14 16:06:27 EST 2000 | zorox
We have an ERSA machine here where we have solder "spikes" occasionally. We have made sure our flux is dispensing properly, we have adjusted z axis speeds, our preheater is heating properly, adjusted XY speeds, etc. Can anyone think of something we m
Electronics Forum | Tue Nov 14 21:55:54 EST 2000 | Dave F
There's a boat load of causes for icicles. Favorites are: * Conveyor speed too high * Conveyor angle too high * Contaminated solder
Electronics Forum | Wed Nov 15 10:51:44 EST 2000 | jackofalltrades
Have you tried using offsets to begin to move the head away in the Z axis while it is moving in a lateral ( X Y ) direction. The spikes are difficult on the Ersa, but experiment with hitting the location from different directions may help also.
Electronics Forum | Wed Feb 22 11:33:53 EST 2012 | geb
Hi, We're looking to buy a second user stencil printer with fully automated alignment and ideally 2D solder inspection. We're looking at DEK and we use their 23" Vectorguard stencils already, but can anyone advise a particular model. Probably someth
Electronics Forum | Thu Jun 22 11:20:13 EDT 2000 | Neil
What role does materials and process selection play in helping make products more environmentally friendly?
Electronics Forum | Wed Jan 19 08:44:05 EST 2000 | Rob Douglass
I would like to hear any feedback (good or bad) about the OK Industries BGA-2000 Series BGA and Fine Pitch Rework System. I was not part of the selection process for this machine and my initial opinion is that this unit may be "under-powered". Loo
Electronics Forum | Mon Nov 27 17:29:13 EST 2000 | Dave F
Contact: Graham Naisbitt
Electronics Forum | Mon Sep 18 20:20:14 EDT 2000 | Dave F
What kind of vision system do you use in your system? Why was that selected?
.gif)
winsouce.jpg)