Electronics Forum | Fri Oct 26 13:29:03 EDT 2001 | Chris
I am looking for opinions on inline adhesive dispense equipment. I am considering Creative Automation, GPD, Asymtek, and Camalot. I will be dispensing dots of conductive adhesive about .010" in diameter. Thanks, Chris
Electronics Forum | Tue Oct 30 19:44:12 EST 2001 | davef
I haven�t read this, but maybe you can do a report for us. Look at: �Achieving Ultra-Fine Dot Solder Paste Dispensing� http://www.uic.com/wcms/WCMS.nsf/index/Material_Dispensing_0.html
Electronics Forum | Mon Oct 29 19:48:03 EST 2001 | davef
Sounds like the connector is not solderable. * Do they take solder when hand soldering? * Do they take solder when using a hotter flux than you normally use? * What flux are you using? * What are the materials used in fabricating these connector le
Electronics Forum | Tue Oct 30 06:41:11 EST 2001 | Billy Bunther
Hi All, Just enquiring about ways of tracking ,scheduling and performing pm's without affecting production etc Rgds Billy Bunther O'brien
Electronics Forum | Wed Oct 31 11:01:02 EST 2001 | dougie
Hi Dave, Thanks for the suggestions. To clarify a couple of the points... - What do you qualify as "small" & "large" parts? - Do not make the pad narrower than the lead width. The nominal or the maximum? If I use the maximum width I'll be back to s
Electronics Forum | Thu Nov 01 17:32:13 EST 2001 | davef
"small" versus "LARGE" parts? Jeez, what do I know? We don�t have a formal definition. They�re the ones that make you say: �Now, that�s a BIG-ass part!!!� �nominal� versus �maximum�? Yes, yer correct.
Electronics Forum | Tue Oct 30 19:14:21 EST 2001 | davef
I'll ask you the same questions as this poster ... http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=4627&mc=2
Electronics Forum | Wed Oct 31 11:47:07 EST 2001 | Denis Carrier
We need to convert 150 large 28 pin DIP I.C. for SMT assembly. We mean, bending the leads at 90 degrees apart. Does someone knows where we can go for that ?
Electronics Forum | Wed Oct 31 12:24:21 EST 2001 | Stephen Zhou
We are designing the SM fixture for small PCB, does anybody know where we can get the spring holder which can hold the PCB to the fixture? Who is the manufacture for this part? Thanks in advance. Stephen
Electronics Forum | Wed Oct 31 14:27:38 EST 2001 | raton
Yup, And they work VERY well. But they don't sell them, they only put them in product that they make. Summit Precision Inc 5825 South 25th Street Phoenix AZ 85040 Contact Mr Dennis Miller (602) 268-3550 Boca
.png)
