Electronics Forum | Tue Oct 28 14:03:20 EST 2003 | Bill
Thanks for the help ---one of our test techs checked the power supply and it reportedly is good. Thanks again, Bill
Electronics Forum | Wed Oct 29 20:12:02 EST 2003 | franklam
Back to square one, is your monitor physically damaged or is it mulfunctioned? Try the local monitor repairing tech's, may give u a surprise. We had the one at the front panel fixed by a local repairing guy here,(cheap $75). It works.
Electronics Forum | Sat Oct 25 23:33:23 EDT 2003 | Dean
I have not used either of these chemicles. However, I would contact the manufacturers and explain your situation. No one will know better than them.
Electronics Forum | Fri Oct 24 14:24:12 EDT 2003 | Pete C
Try posting your request on the Equipment Mart of this web site. I'm sure you will get many replies.
Electronics Forum | Fri Oct 24 15:45:05 EDT 2003 | adlsmt
If your boards are 18"X18", what size magazines are you using? Most unloaders only handle 18"x18" magazines. If thats what you want I have Panasonic and Fuji unloaders for $2,000.00/ea I am an end user not a broker.
Electronics Forum | Fri Oct 24 13:41:39 EDT 2003 | albertoh
I need some information about coplanarity specs for QFP's. I try to setup coplanarity inspection on my QP242 but i'm not sure about what value i need on each parameter in order to setup my diferents parts data for this option. Thanks in advance.
Electronics Forum | Fri Oct 24 17:04:43 EDT 2003 | Joe
Any information on the difference in a thermal profile between lead free and regular Lead profile? Also, why use flux with Lead? Why not with Lead Free? Thanks, Joe
Electronics Forum | Tue Oct 28 09:24:10 EST 2003 | davef
Running a soldered BGA through a wave solder pot is very risky: * 230-240*C temperature of the pot could damage the device. * Solder in the pot will certainly cause bridging between BGA solder balls. * Solder in the pot could melt BGA solder balls.
Electronics Forum | Tue Oct 28 10:45:22 EST 2003 | Gabriele
After following the suggestions above, and where it would not be possible to mask BGA by soldering fixture, a Kapton tape (pre-punched) can be placed under BGA ( wave solder source side ) it can help to keep temperature low enough avoiding "seconda
Electronics Forum | Mon Oct 27 09:47:39 EST 2003 | yiannis
hi, Are there users of Aura - a wave soldering machine of Automation ?. I d like to buy a copy of the manuals and to ask a few questions. Thanks
