Electronics Forum | Wed Apr 20 10:28:34 EDT 2005 | James
Anyone know of a place to get the vacuum pads for the traverser of the LCS units? Assembleon want over $100 each for a ring of ESD foam! ! ! ! If I can't find a reasonable source I guess I will try to make them myself. James jseagle@zworld.com
Electronics Forum | Wed Apr 20 11:26:30 EDT 2005 | bobsavenger
Could someone tell me the recommended board spacing when going through reflow? I've heard a couple different things so I was wanting to get other opinions. Thanks Bob
Electronics Forum | Thu Apr 21 08:26:09 EDT 2005 | Rob
Hi, you may want to try some of the following: Chip Inductors Transistors Diodes Logic Vregs I know of a few companies that may be looking for representation in this area, of which I can e-mail you the details. Best regards, Rob.
Electronics Forum | Thu Apr 28 15:45:21 EDT 2005 | stepheniii
What about things like tweezers, vaccuum pens, and hand held optical tools? I mean jewelers loupes and magnifing glasses. You might want to carry two classes. Economy models at low cost and higher end more expensive ones. Stephen
Electronics Forum | Mon Apr 25 12:11:29 EDT 2005 | lyrtech
Hi, Does anyone know the rules to calibrate a feeder without any expensive jig test? We want to do that by our operators. Does anyone know the procedure? Thanks
Electronics Forum | Wed Apr 27 13:50:01 EDT 2005 | russ
You will want the square in this case to be .013" with rounded corners (slight overprint). I do not see why you would need a type 4 paste for this. the aperture as it sits should release well but obviously there is something wrong.
Electronics Forum | Mon May 09 08:31:23 EDT 2005 | jdengler
Grayman, You might want to read this paper. http://www.speedlinetech.com/docs/Equipment-Lead-Free-Wavesoldering.pdf Jerry
Electronics Forum | Mon May 09 16:23:08 EDT 2005 | Pete Roy
Has anyone here had direct experience using this oven for Lead Free? I am considering purchasing one, but I want to be certain it will handle low volume lead free work. Pete
Electronics Forum | Wed May 11 13:27:30 EDT 2005 | Sam Ho
i want to know which type of solder paste and reflow profile can support the solder pad with nickel but not covered gold on the pcb.
Electronics Forum | Thu May 19 04:31:43 EDT 2005 | dougs
Thanks guys, thats pretty much what we have done as well, just wanted to check that it's ok to do it this way rather than do a full FMEA for a product. We'll know for sure in a couple of weeks when we hand in the PPAP. cheers
winsouce.jpg)
