Electronics Forum | Fri Jun 16 08:37:51 EDT 2006 | Chunks
What type and brand of fluxer?
Electronics Forum | Thu Jun 15 22:17:02 EDT 2006 | Thanagon
I'm now have target to flux saving. Could you please tell me. If we adjust level of spray fluxer nozzle up then we can saving cost of flux Quantity usage? What Others must adjust? such as pressure , flux flow. Thank you All for advise.
Electronics Forum | Sun Jun 18 21:41:58 EDT 2006 | Thanagon
Dear Sir, We used TAMURA type : TAF30-12DNS. This type nozzle can't moving up and down but we will modify that.Please comment that is O.K.? Regards, Thanagon
Electronics Forum | Wed May 24 04:28:18 EDT 2006 | ge_lim
Hi Anyone use Warton Active '8' flux to clean the nozzle? Share me your experience
Electronics Forum | Tue Jul 05 10:27:34 EDT 2005 | GEB
The nozzles are brand new too (got them friday). 08MPF (0.08") is their part number. I tried using the air kiss feature in the setup mode and found that it blew the nozzle off the nozzle holder, not sure if this is ment to happen in this mode, but t
Electronics Forum | Tue Oct 10 12:32:08 EDT 2006 | RLM
Larry, I have had this problem in the past. It turns out that there wasn't enough "Z" on our nozzle pickup locations. When a nozzle change occured the nozzle would not be fully seated on the Z-rod. When the Z-rod is driven down to pick the first part
Electronics Forum | Mon Feb 20 18:39:11 EST 2006 | Aaron Zanchez
looking for ok industries nozzles
Electronics Forum | Wed Apr 19 14:46:08 EDT 2006 | cuculi54986@yahoo.com
We run Panasonic chipshooters, so our small nozzles are not cylindrical. We would use the smallest nozzle we have on our heads which I believe is a Panasonic "MF" size, the same nozzle we'd use for 0603 size components.
Electronics Forum | Tue Oct 10 12:34:43 EDT 2006 | bobpan
Larry, Do a runstep nozzle then open the door and look and see if the nozzle is all the way on. Push up on it and see if it moves up
Electronics Forum | Tue Oct 31 23:46:12 EST 2006 | fastek
Which nozzles are coming up NG on the large camera? If it's the smaller ones, don't worry about it. Those nozzles don't use the large camera anyways. Be concerned if the small nozzles are coming out NG on the small camera.
