Electronics Forum | Tue Nov 20 23:20:02 EST 2007 | er_pe
Please take a look at the write ups here on this forum regarding the ACE KISS systems. Have you taken a look at and reviewed the Pillarhouse systems ???
Electronics Forum | Thu Dec 06 11:51:11 EST 2007 | lysik
We use a dual pot ERSA system. It is outstanding. Saved about 3000 hours of labor a month. Very expensive but worth it. We also looked at JUKI it was also a nice system. It was very flexible but the ERSA was better suited for high volume.
Electronics Forum | Tue Mar 06 08:33:40 EST 2007 | cardinal
You can get a topside edge-clamping system to fit your AP HI E printer from Gridlok. They make a universal tooling system and topside edgeclamping system for the AP series and UP 2000 series printers. The Y snugger tooling option when ordered with t
Electronics Forum | Fri Dec 28 08:21:12 EST 2007 | clampron
Good Morning All, I am looking into solder paste inspection systems. I have used a solder paste height inspection system in the past. We have derived less than usefull information from this system as it will only measure the pad that was taught. I h
Electronics Forum | Sat Mar 03 13:36:40 EST 2007 | grantp
Hi, We are looking for a new SMT report system, you know the ones that let you align and easily solder BGA's and the newer lead-less packages that are small and have leads under the package. We have looked at a few, and some use the removal time t
Electronics Forum | Thu Mar 15 17:19:03 EDT 2007 | bT_Solutions
By "digital video inspection system", I'll assume you mean AOI. I have only dealt with one AOI system, YesTech, and in my opinion I'd say that AOI is much more consistent and advantageous than manual microscope inspections. Specifically, with the Yes
Electronics Forum | Wed Jan 17 22:35:21 EST 2007 | JNet
Is the oven air or nitrogen? If it is air I would suggest more exhuast to pull the flux vapors out if the oven before they can condense in the cooling. If it is a nitrogn machine that makes it a little more complicated. If the filter system is clogge
Electronics Forum | Fri Apr 13 04:10:21 EDT 2007 | CH
We would like to get feedback from users of SMT REWORK STATION especially for BGA's.Dear users, kindly give us ur feedback on BGA REWORK system on the following. 1.Is HOT air based BGA rework system be better than IR rework system.if so pls clarify.
Electronics Forum | Thu Aug 16 10:59:08 EDT 2007 | mika
Did You recieve any s/w with it? If something has happend to the hard drive or something could happens in the future then you need to reinstall... S/W ver. is written on the the s/w package. It should contain s/w for: The OS (Operating system), Visi
Electronics Forum | Tue May 22 07:55:05 EDT 2012 | rway
Although not listed in your post, I recommend YesTech. I have been using them since 2007. We have two M1 systems, and they have been good machines. We evaluated three: YesTech, Mirtec, and Christopher. Of the three, the YesTech system caught more
