Electronics Forum | Thu Sep 29 12:04:38 EDT 2011 | swag
You need SMEMA communication beteen your machines and your conveyor.
Electronics Forum | Sat Oct 01 20:06:27 EDT 2011 | edwaterfall01
If you can provide contact info I will discuss programming your conveyor.
Electronics Forum | Fri Jul 15 14:45:20 EDT 2011 | cyber_wolf
http://www.vossbelting.com/
Electronics Forum | Thu Sep 29 12:56:53 EDT 2011 | leemeyer
Smema is connected and works and the 2 machines will communicate. It seems as though the conveyor wants to see a board eveery 30 secs or so, If the upstream can give it one in this timeframe everything is good. If not it times out and the yellow butt
Electronics Forum | Wed Jul 13 13:23:34 EDT 2011 | kkay
We have multuiple pcb transport conveyors that use the 10mm wide flat green blets on either edge. Does anyone know of a kit to purchase where we could make our own or a company that supplies different sizes? Thanks
Electronics Forum | Wed Jul 13 13:48:12 EDT 2011 | markhoch
I've bought conveyor belts from Michigan Industrial Belting. http://www.mibelting.com They were able to make some custom belt sizes for me that I couldn't find anywhere else.
Electronics Forum | Fri Sep 30 06:26:27 EDT 2011 | leemeyer
Thanks NRS, I do not have any documantation for this conveyor but I thought something like that was going on. I am in Northeast Ohio.
Electronics Forum | Wed Jul 13 14:24:43 EDT 2011 | leemeyer
Look at http://www.habasit.com. They sell the belt and the tools to cut and join the ends. I remember looking into this several years ago and the cost of the tooling was so high that it didn't make sense for us to make our own belts.
Electronics Forum | Thu Sep 29 10:34:46 EDT 2011 | leemeyer
I recently bought a used Universal conveyor #5362I. All I need it to do is pass through boards from 1 machine to the next without operator intervention. The only way I can get it to accept a board from the upstream machine is by pushing the yellow bu
Electronics Forum | Thu Sep 29 19:45:23 EDT 2011 | edwaterfall01
The conveyor is programmed to turn off the belts and go into an error condition after 30 seconds if the board has not passed the output sensor on the conveyor. The intent is to indicate a board jam and prevent damage to the board or belts. On convey
.gif)
winsouce.jpg)