Electronics Forum | Fri Sep 11 17:51:55 EDT 2015 | simons
Thanks Armando. What is the easiest way to check if the motor is bad?
Electronics Forum | Tue Sep 01 01:05:24 EDT 2015 | rgarcia0626
I'm not familiar with you machine but it seems the problem is not the motor. if there's a manual I/O, switch on your conveyor from there and check if there's a voltage going into the motor.Check the control boards for the conveyor, relays and sensors
Electronics Forum | Fri Sep 11 12:44:16 EDT 2015 | simons
Our Philips Orion shows a L049 motor error immediately after we turn it on. Note that the Y axis servomotor was very hot prior to the last shutdown. Is this a problem with the motor or one of the boards?
Electronics Forum | Tue Sep 01 10:55:41 EDT 2015 | emeto
Hi, 1. Take a multi meter and measure the voltage - I assume it is a DC motor(probably 24V). If you don't, check power supply,cable, relays and Driver for the motor. If you do have voltage, check sensors(sometimes sensor activated may stop your con
Electronics Forum | Fri Sep 11 17:02:10 EDT 2015 | adeanda74
Simon, Normally that error is caused by a bad motor but also there is a possibility that a driver board or even the servo board are defective and last but not least check all your cables and connections. finally let me mention that you can also recei
Electronics Forum | Tue Sep 01 11:12:18 EDT 2015 | zombee
Problem is solved! There wasn't voltage on motor inputs (only 5-10V AC) when the motor connected correctly, but was ~210V AC without motor. Firstly, I exchanged the motor speed control relay (Panasonic G-series type), but the result was same. (the a
Electronics Forum | Thu Oct 15 10:21:30 EDT 2015 | azdback
troubleshooting a table lift error on MY12. Error code: F-MOT_Releaseboard conveyor lift/1304. Basically, the table got stuck on the up position. Also bench tested both lift motors and they are ok.Rotated the lift motors manually to test the encoder
Electronics Forum | Mon Aug 31 15:21:04 EDT 2015 | zombee
Dear Users! I have a Topaz pick&place machine, but the conveyor motor is not working. 1st test - production: Start production in "operation" menu: if I put the PCB the entrace of machine, the assembly head-bank picks up the first 8 components (prec
Electronics Forum | Mon Sep 14 16:36:40 EDT 2015 | simons
Upon start up our QSA machine is giving us the following errors. Cant reset motor alarm (x axis) Cant reset motor alarm (y axis) Cant reset motor alarm (z axis) What are the possible reasons for this? Thanks
Electronics Forum | Fri Jul 10 18:47:27 EDT 2015 | alphatronique
make sure noting stock in the X ,and motor brake work usually machine supply 24V to motor brake wire for release brake then move until hit the end stopper for init motor if brake keep on that will the error message i got it often on the Z cause
