Electronics Forum | Mon Jun 03 11:51:44 EDT 2002 | Troy
A 50KV machine will allow you to see solder bridges and balls under the BGA. It will also allow you to check placement and can "see" through the metal housing. If you want to inspect for voids, then you what to look at equipment in the 100KV range.
Electronics Forum | Fri Jul 28 12:13:38 EDT 2017 | dontfeedphils
Ironically enough, inline wash system belts work well for placing on top of small assemblies inside wash basket to avoid bouncing around like you've seen. This of course assumes you have access to an old belt like that. Point being, try to find som
Electronics Forum | Fri Jul 28 09:24:17 EDT 2017 | jpepke468
A lot of our PCB's are being damaged by our water cleaner, it is a Steolting Triton, and I beleive it is due to the drying section in the machine. The air its blowing on the boards is flipping the boards around on the conveyor and smashing small deli
Electronics Forum | Fri Jul 28 11:16:09 EDT 2017 | robertwillis
Yes it happens with any inline cleaner with small or light boards the pressure can cause them to flip. If they lodge in the links they can also cause damage to the conveyor. For small boards, flexibles etc you do need a mesh fixture of some sort or l
| 1 |
