Electronics Forum | Fri Aug 07 13:03:53 EDT 2020 | assuredtech
SMT Forum, Does anyone know if the Sanyo laser alignments can be replaced with the Cyberoptics brand? If so is it plug and play or does it require any software or machine configuration changes. Thanks in advance
Electronics Forum | Mon Jan 02 13:52:03 EST 2023 | thanhctran30
Does anyone know the services engineer password for Ke2020? I'm trying to check to see if laser is bad and it required service engineer password. Thanks,
Electronics Forum | Fri Aug 07 14:52:43 EDT 2020 | glasscake
Does anyone have a comprehensive manual or some pages on how to setup/how the laser height functions work on a Mirtec MV-7U? (Mirtec Inspector 4.5.6) Even a sentence describing what each input for these tools do would be amazing. I FINALLY was able
Electronics Forum | Wed Aug 12 17:57:32 EDT 2020 | glasscake
Due Diligence Post: Figured out my issue with the laser itself, it was set up in RS422 mode and it should have been setup in 0-10v analog out. As far as actually using the tools i have not got that far yet but I will DD again when I get that far. I
Electronics Forum | Fri Jun 19 06:18:41 EDT 2020 | vinitverma
Look for Philips Emerald (3 Phase supply) or it's predecessor Eclipse (single phase supply). It has 2 heads, Laser + Vision alignment (no mechanical alignment).
Electronics Forum | Fri Aug 07 16:45:42 EDT 2020 | emeto
The user manual you ca just request from Mirtec and they will send it to you. They supply electronic version for the last years, so try to find it somewhere on your machine PC first.
Electronics Forum | Thu Jan 23 12:39:25 EST 2020 | rlackey
Hi Phil, Tabs every time for me, but running in volume so the slow down in tool travel for cutting important. Have used Cencorp 1000 & 1300BR, and Asys ADS01 - both in line systems with grippers from the top to hold the board and the router underne
Electronics Forum | Fri May 29 14:34:37 EDT 2020 | huske
BEST Inc offers this type of product for custom shape cutouts. You can buy standard circles and squares from many places. soldertools.net/conformal-coating-tapeshapes-laser-cut-3m-type-401-engineering-cad-work/ solder.net/painters-tape-cus
Electronics Forum | Fri Aug 07 14:55:41 EDT 2020 | glasscake
Also yes I know about Mirtec's second owner program but it is not an option considering the cost of that is almost as much as it cost to buy the machine. Does anyone have like a developer manual that gives in depth explanation of the functions/tools
Electronics Forum | Fri Aug 07 19:05:11 EDT 2020 | glasscake
I was told by Mirtec I could not get any manuals without buying the second owner support. I have a simple manual that goes over making a program, creating parts. That manual covers using the Mount inspect, IC inspect, Chip inspect tools but nothing
