Electronics Forum | Tue Nov 27 19:41:53 EST 2007 | g2garyg2
Well, there seems to be many opinions, many of which could be correct, however... With the proper laser they can be quite good for soldering. Here are a few guidelines I would like to suggest. 1) Have your product soldered first (by the vendor) 2) T
Electronics Forum | Fri Aug 07 13:03:53 EDT 2020 | assuredtech
SMT Forum, Does anyone know if the Sanyo laser alignments can be replaced with the Cyberoptics brand? If so is it plug and play or does it require any software or machine configuration changes. Thanks in advance
Electronics Forum | Thu Sep 14 06:18:00 EDT 2023 | deniseburton
Hello, mcdvoice It seems like your Juki RS-1R machine's laser height calibration may be off. When measuring a 0402 resistor, it consistently reports heights around -0.60 to -0.70, causing pickup issues during production. Manually adjusting it to -
Electronics Forum | Tue Aug 04 01:55:29 EDT 2020 | cbeneat
How much adjustment is needed? Adjusting the snap off will get the PCB tighter/looser to the stencil. But this is only a 3 to -3 MM adjustment.
Electronics Forum | Mon Sep 25 09:42:51 EDT 2006 | slthomas
It sounds like it's just failing the laser align step. Try changing the align type for the part to "2" and see if it places it. If it's failing the laser align and you have valid part dimensions I can't help much but you might consider opening up th
Electronics Forum | Fri Aug 07 14:52:43 EDT 2020 | glasscake
Does anyone have a comprehensive manual or some pages on how to setup/how the laser height functions work on a Mirtec MV-7U? (Mirtec Inspector 4.5.6) Even a sentence describing what each input for these tools do would be amazing. I FINALLY was able
Electronics Forum | Fri Nov 04 13:35:17 EDT 2011 | travishemen
Nordson has a viscosity control system and a laser fan width control option. We use the viscosity control system on our machine. Basically it heats the material to a set temp. The laser fan width measures the spray pattern width with a laser and a
Electronics Forum | Thu Aug 20 11:38:57 EDT 2020 | stephendo
You might have to adjust both ends to match the middle. Is it an autowidth oven?
Electronics Forum | Mon Aug 03 07:14:38 EDT 2020 | bangir
Hi, How to adjust the table height of Screen Printing EKRA X5? Could you share me the Manual System Operation?
Electronics Forum | Tue Aug 04 13:45:03 EDT 2020 | oxygensmd
There are one value for thickness during PCB-teach function which is the PCB thickness. The other one is the camera focus in machine option but it is a dangerous function because the camera focus is adjusted by raising/lowering table.
