Electronics Forum | Fri Oct 09 22:54:35 EDT 2020 | dekhead
Most likely cause is Servo AC drop.
Electronics Forum | Tue Feb 11 15:31:10 EST 2020 | sumote
We have not used out tray handler in several years, and when I had a need arise the thing now throws a Servo Error "MTU1 ALARM [11081010]. There are 4 servo packs in the cabinet. When I try to initialize/zero out the machine the 2nd and 4th servo pa
Electronics Forum | Tue Jun 09 16:48:56 EDT 2020 | bboyer
All ready resolved. Looks like there was a loose cable on one of the modules, which would not allow it to command the low voltage servo module to run the motor in reverse.
Electronics Forum | Mon Aug 31 09:16:54 EDT 2020 | aurash
After reading the machine logs it seems that the problem is on the X-axis but the safety mechanism is disabling all the Servos and the Axis system (all axes) are in error state (that's why the error messages are showing on different axes) The JUKI m
Electronics Forum | Tue Jun 23 13:50:05 EDT 2020 | dltechltd
505.05 SP2 Hotfix3 After this, we were able to work with the machine until 1 week and the machine broke again. A small zener diode exploded on a Servo card, and we replaced it. Next reboot, the MC system halted, because an SRBS error. We have aske
Electronics Forum | Sat Aug 08 23:38:06 EDT 2020 | jmelson
Well, the machine is here, it has some probems that I need to diagnose, and now I ***REALLY*** need the manuals (both maintenance and operations). Two problems. One is that it will only come "ready" (servos powered on) ONE TIME per day! I'm totall
Electronics Forum | Mon Aug 31 16:48:16 EDT 2020 | aurash
I wish it was so simple :-) In their wisdom the machine designers choice was to have servo drivers with two channels (one channel less powerful and one channel more powerful) - so each card is driving a X motor and a Y motor.(the X axis is made of 2
Electronics Forum | Sat Nov 28 22:12:33 EST 2020 | tueftler
Hi there :) I have an used IPulse M1 PnP machine since one week. In 2016 the machine had get a full service with update the OS from WinNT to the newest WinXP-Program. I had tested the machine on sellers production hall - All was running great. Now,
Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer
Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits
Electronics Forum | Fri Jun 19 15:03:15 EDT 2020 | jmelson
OK, I am really happy with the robustness of my CSM84. I wonder how hard it would be to hack up one of these 3-phase machines to run off single-phase power? Mostly, it just feeds a big DC supply for the X-Y servos. 2 heads with ANE should be just FI
