Electronics Forum | Mon Feb 10 17:32:59 EST 2020 | SMTA-Alex
Check that the new vacuum tubing isn't restricting the theta rotation. It can "wrap" around the Midas head, if not secured properly.
Electronics Forum | Fri Feb 14 16:55:07 EST 2020 | bilalfarooqi
Thanks so much Bruce and thanks Rob.
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Fri Feb 07 13:17:32 EST 2020 | bk
I am assuming you are initializing each motor individually through the service program. The z motor theta is hard to see so I put a mark on it with a colored marker so you can watch if the midas tool nozzle is actually turning or not. You should be a
Electronics Forum | Mon Feb 10 22:29:07 EST 2020 | bilalfarooqi
Thanks all. I didn't check any further as I dont want to mess the midas head any further especially because I'm not sure how to take it out to work on it.
Electronics Forum | Fri Feb 14 12:37:08 EST 2020 | bilalfarooqi
Hey Rob, I don't know where the MOT cards are located on MY12 or how to change them. Do you have any documentation or instructions on how to change the MOT cards?
Electronics Forum | Fri Feb 14 14:35:44 EST 2020 | emeto
From what I remember, shut off machine, unplug cable/hose, unscrew 4 screws and the head is out.
Electronics Forum | Fri Apr 24 17:42:04 EDT 2020 | rodrigo
I checked and the fine theta motor is spinning. Thank you so much for the help.
Electronics Forum | Wed Aug 26 14:41:44 EDT 2020 | emeto
Part library is big enough problem. Whatever machine you pick you will be able to transfer XY, Theta coordinates as well as reference designators. This will help in programing a little, but this is all you will gain. all packages, vision algorithms
Electronics Forum | Fri Feb 07 11:06:50 EST 2020 | rgduval
Start by checking cables. Odd that the C-motor would initialize, but, then, theta fails when you move the Z-motor. Sounds like something's got a loose connection somewhere. Possibly in the connector going into the C-motor. If that's a no-go, try
winsouce.jpg)
