Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Tue Apr 21 02:28:54 EDT 2015 | dinhhuunam
Juki GL-1.... Any thoughts? I'm New to the > industry and I'm trying to buy a new screen > printer. I have two in mind, DEK and Juki. Hi Sir, I'll advise you the SJ INNOTECH Vision Screen printer Best Solution & Service for You Model HP-520S Hi
Electronics Forum | Tue Sep 29 01:51:37 EDT 1998 | Earl Moon
| I'm going to purchase a screen printer. | I've looked at the SMTech/Sigma 500 (also called Quad AVX500). | Has anyone any comments to this machine or production experience? | Anything would be appreciated. | I'ld like to hear any other type of ma
Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
Electronics Forum | Mon Feb 03 18:48:45 EST 2025 | tey422
You might want to order the SMT fixtures with clamp(s) similar to the one I attached. Just make sure before sending the board into reflow oven that the connector is clamped straight and aligned.
Electronics Forum | Thu Dec 16 06:06:52 EST 1999 | Stefan
Check the print gap and check the clamp edges, sometimes the clamps is damaged causing a distance between the PCB and the screen. Good luck
Electronics Forum | Mon Apr 24 09:43:47 EDT 2006 | printerman
What you describe is the X snuggers fitted into the workholder which do need either a flat board or good vacuum to work. There are several solutions. One solution you can try yourself is to use Vacuum cups, ( bellows type) designed into the workholde
Electronics Forum | Wed Jun 29 10:26:58 EDT 2011 | remullis
I've been using 29x29 framed screens for years. I have a company that has come up with a adapter that would mount in my screen printer and utilize just the foils of screens. It basically fits and is clamped into the adapter. I am struggling with floo
Electronics Forum | Mon Jan 06 21:23:21 EST 2025 | lundail
Hello, We recently purchased an MPM 100 screen printer on an auction. The machine was supposedly working but we cant get it to boot up. On launching the software we get the following "Connection failed with the following error:'Vision not connected'
Electronics Forum | Thu Jun 30 13:00:14 EDT 2011 | scottp
I've been using a DEK Vectorguard frame for a couple months now and like it a lot. It uses air to clamp/unclamp the foil and both DEK Vectorguard and Alpha Metals Tetrabond foils fit the frame. Just about any decent stencil supplier sells Vectorgua
