Electronics Forum | Mon Aug 19 07:42:59 EDT 2019 | robl
At least one of them looks like a handling issue to me - the last picture shows the crack going into the termination as a scratch on the right side - as if someone has slid another board into a magazine without leaving enough space. This one looks li
Electronics Forum | Fri May 15 16:02:40 EDT 1998 | John S
If you have a chance check out the MSD artical (Page 69) in April Electronic Packaging & Production. It is one of the worst articals with unsubstantiated conclusions I have ever seen. Notice Figure 3 on page 72, Caption indicates two simular compon
Electronics Forum | Mon Oct 29 20:19:44 EST 2001 | davef
DON'T do it!!! The two problems you'll have are: 1 Poor manufacturing process control, resulting in weak solder connections. 2 Weak solder connections are stressed, when the board is straightened upon installation in the "box". There's several hits
Electronics Forum | Mon Jan 13 18:22:55 EST 2003 | davef
100 sec) and decrease reflow temp to 205C. * Understand that voids are primarily process indicators. There is experimental evidence that voids retard crack propagation locally around the void on a temporary basis. There is no standard, IPC or otherw
Electronics Forum | Fri Oct 30 01:07:34 EST 1998 | Earl Moon
| I am a recently graduated Process Engineer. I am working for a company developing and manufacturing printed circuit boards. I am looking for a web link, magazine article, book, etc which describes the processes which happen at a board house. More s
Electronics Forum | Thu Sep 10 21:48:37 EDT 1998 | Dave F
| I'm very familiar with the great board space savings of BGA and all the "claims to fame." However, can someone out there tell me if any concern exist in the inspection realm. Additionally, solder cracking, CTE/TCE mismatches, no leads for stress re
Electronics Forum | Fri Feb 22 08:26:51 EST 2002 | davef
You are correct. The gold dissolves in the solder. The gold is meant to protect the nickel from oxidizing, so that you can solder to the nickel. Obviously that didn�t work as planned. Your background information is very sparse. Two things come
Electronics Forum | Thu May 06 18:07:59 EDT 1999 | JohnW
| | | Can anyone pls email me a typical temperature profile for wave soldering process. | | | | | | Thank you vey much. | | | | | | rdgs... | | | | | Typical depends on the processes you're developing. | | | | Key factors in my experience are f
Electronics Forum | Sat Oct 02 20:19:19 EDT 1999 | John Dwinell
| | I am currently in the middle of a company wide war and I'm looking for data (AMMO). Here are the problems: | | | | 1) I am looking for anyone who has done or seen any reports on Thermal Shock to smt parts and/or via holes caused by Soldering Ir
Electronics Forum | Sun Aug 08 20:59:55 EDT 1999 | Dreamsniper
| | | What oven temperature should be used to reflow solder (Sn63Pb37) on a PC board (0.075" to 0.100" thickness) in 5 to 10 minutes? | | | | Profiling - tedious but important. As said, start with the paste manufacturers recomendation which is usua
| 1 |
