Electronics Forum | Mon May 22 17:54:46 EDT 2017 | zsoden
Thanks for the replies. The single missed lead is a bit odd - we usually have an entire area missed and that's due to the board not sitting properly in the pallet fingers. I figured in this case it was likely due to poor fluxing? We have always str
Electronics Forum | Tue Oct 12 05:09:13 EDT 1999 | Brian
| | | | | | | Can anyone tell me the formula/method to determine | | | | | | | the amount of weight that solder's surface tension can support. | | | | | | | (ie: Maximum weight of components soldered onto a bottom side | | | | | | | of a board during
Electronics Forum | Tue Jun 08 17:52:53 EDT 1999 | Chrys Shea
| | | Hi,my master | | | How to iron out such soldering bridge with below conditions: | | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | | 3.using s
1 |