Electronics Forum | Fri Jun 13 11:28:40 EDT 2014 | jimmyboz
There is a small cylindrical sensor on the air cylinder that that actuates the chuck. I can't remember if there are one or two. Its (they) are about 4mm x 20mm and I think (it) they have a signal light. Make sure it is mechanically working properl
Electronics Forum | Fri Jan 31 11:45:52 EST 2014 | emeto
Hi, to get better image you will probably need higher voltage(depending on how close you want to look). The closer you get the higher the voltage should be. Here are some tips for machine calibration: 1. Make sure your board is on focus. I don't kn
Electronics Forum | Mon Mar 24 20:30:01 EDT 2014 | davef
The "correct" answer is: Use the tests and methods that you used to qualify your solder paste in the first place. That sounds good but might not be all that practical for practicing assembly-types. Here's something that's not as good, but will give
Electronics Forum | Wed Feb 05 08:51:13 EST 2014 | emeto
What I think it does is to calibrate the camera. You have your tube on the bottom and your camera on the top. For my machine(Dage) I have to put the board I am going to examine inside and select a point on the board surface. THen I just click on this
| 1 |
