Electronics Forum | Sun Oct 30 20:41:57 EDT 2011 | conjugate
I`m now doing my major project related to Automated surface cleaning for PCB after I found out there`s a lot of problem with rejected PCBs, which is almost of them caused by the contamination from the materials itself. After trying a few solutions by
Electronics Forum | Sun Oct 30 20:43:42 EDT 2011 | conjugate
I`m now doing my major project related to Automated surface cleaning for PCB after I found out there`s a lot of problem with rejected PCBs, which is almost of them caused by the contamination from the materials itself. After trying a few solutions by
Electronics Forum | Wed Jun 01 11:02:57 EDT 2016 | claudea2
I have 3 used Quad 4Cs and the nozzle changer on one machine never worked. I decided to troubleshoot it this week. I repaired the changer by changing a defective optical sensor but I still get error 17 when I try a run-step nozzle 1, 2 or 3. Error 17
Electronics Forum | Wed Nov 02 16:35:20 EDT 2016 | csm
Dear FUJI Specialist, I need your HELP, we have an CP8-42-E and machine was working properly and from one day to another when we Turn ON the machine make all the startup and check all the list, when all is ready, you have to Puch Ready and automaticl
Electronics Forum | Tue Jan 05 21:24:34 EST 2021 | rmitchell
We use to have to replace the "dog" tube when it got rounded out or worn a little. If you you already cleaned it and can see the red light going off and on when you gently push up on the nozzle it is just not seeing in time and it gives the nozzle c
Electronics Forum | Sat Aug 19 22:54:12 EDT 2023 | sonavc
Hi The machine run fine. Now I had the problem ZL or ZR driver Alarm. Turn on machine, everything is checked O.K I can be able to home the machine. When just start auto, the assembly or semi -auto. The machine is stopped, and show driver alarm ZL or
Electronics Forum | Thu May 03 22:51:14 EDT 2007 | jmelson
I am still learning the CSM84, but have gotten one board programmed and working. Now, I'm doing the next board, and need to use the mechanical alignment unit for a 22 x 22 mm TQFP. This chip is too large to clear the jaws on any head. Can the CSM h
Electronics Forum | Fri May 01 00:27:12 EDT 2009 | rodrigo
Hi all, We had a servo amp replaced (SA-6) and the machine worked with no problem for the first panel (this panel of 10 only needs a TQFP100 from the MTU). Then I got the "Servo NG" error again. One of the servo paks showed a "7" on the LED. The err
Electronics Forum | Tue Dec 07 10:47:09 EST 2010 | walkbury
As a high mix, low volume CEM who deal with a lot of free-issued kits, we are heavily reliant on foil (tape cover) extenders. We don't usually bother with splicing as our machine feeders (Simenes Siplace and Samsung SM321) are designed in such a way
Electronics Forum | Fri Jul 09 17:52:43 EDT 2021 | glasscake
Hello, I have a Topaz-X that is losing its R origin as it runs. The issue can be seen in the following test: Set the machine to ignore vacuum/ignore alignment and have no feeders in the machine also set the nozzles all to fixed. I run a servo orig
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
winsouce.jpg)
.gif)
