Electronics Forum | Mon Oct 05 10:25:43 EDT 2015 | emeto
I know DEK is selling some dielectric cleaning liquid that is 20 times more expensive than alcohol. You should put this liquid on your stencil cleaner.
Electronics Forum | Mon Oct 18 08:11:49 EDT 1999 | Graham Naisbitt
20 times per hour. Lights should be behind "Georgian wired" glass rather than Ex'd' and all electrics should be hard-wired. Zone the room 1 = safest = around the coating machine and drying cupboards 1 meter from material. Zone 2 = > 1 meter away = OK
Electronics Forum | Thu Sep 19 14:25:30 EDT 2002 | stepheno
Changing the pitch on the newer feeders is a little bit different and involves adjusting the location of a sensor. Where we lose the parts is at change-over. There are some reels that we might put on and take off a feeder 20 times before the reel is
Electronics Forum | Tue Sep 21 10:20:47 EDT 2004 | Arvydas
Hi, all, We are looking for new chipshooter with 10-20K CPH speed. Unfortunately, we are not experts in P&P machines. For the moment we have 2 machines with speed 3-5K CPH and we are going to rise one speed level up. Our products are low to medium vo
Electronics Forum | Tue Nov 15 23:03:07 EST 2011 | supse
Hi I have a problem with one of our MY12 machines, the machine stops very often (approx. 10-20 times a day) writing the following error message : f-mot-msetdyn hydra theta/205(f-hrdw-3). We then have to reinitialize the machine to continue productio
Electronics Forum | Fri Sep 20 13:44:17 EDT 2013 | cyber_wolf
There is no 8mm wrenches involved. The procedure is a little to extensive to post.The only hand tools required are the crows foot jig a set of allen wrenches and an adjustable wrench. You have to remove the shaft crown to get the clutch out. Again..
Electronics Forum | Thu Apr 21 11:43:03 EDT 2005 | davef
We understand the problem of trying to coat over RTV. We have seen the same problem with acrylic and urethane coatings not wanting to stick to RTV. Some acrylics seem to be worse than urethane. Since this is a new product, may be you could pot your
Electronics Forum | Sat Nov 05 09:02:23 EST 2005 | grantp
Hi, The oven we had used an air sensor, however we had heat from the metal oven walls IR conducting into the board. Once you run an oven, the metal retains a surprising amount of heat, and that radiates as IR energy out of the walls, and into the pr
Electronics Forum | Wed Jan 03 21:20:22 EST 2007 | davef
Comments are: * General purpose RTV (RTV-108) releases an acetic acid (vinegar) during cure and corrodes copper, brass and sensitive metals. It is therefore NOT for use in delicate electrical or electronic applications. However, there is an electrica
Electronics Forum | Tue Mar 20 04:13:53 EDT 2007 | chrissieneale
Guys, Unfortunately breakaways aren't an option - they are large boards and we already have problems hand placing components and probing them. The ridges - yes we can remove a few - and that solves one problem (boards bashing together and damaging
winsouce.jpg)