Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Tue Dec 31 13:44:57 EST 2002 | burb1999
Does anybody know of a manufacturer of board stiffeners to put on the edges of PCBs when there going through the oven? I have seen some that C-clamp on the edges which I would prefer but don't have any info on them.. Thanx, Todd
Electronics Forum | Mon Aug 27 09:56:00 EDT 2001 | stefan
I wonder what kind of equipment the board designer had in mind? Are you shure you can do the board with a Mydata ? Where do you put the tray for your 20 mil QFP's? 10 mm thick plus component height also appears to be a problem. Multitroniks can do la
Electronics Forum | Thu Aug 23 10:16:43 EDT 2012 | dontfeedphils
There are a couple of things that I would check. Check the board clamps and make sure that they're in good shape and that they're actually holding the board securely. If those check out I would take a look at the fid camera and make sure that every
Electronics Forum | Mon Dec 20 07:09:03 EST 1999 | Christopher Lampron
Ron, The simplest way to process fexible PCB's that I have found is to use a process carrier fixture. There are companies that manufacture process carriers that are capable of holding flex through stencil, placement and reflow. The carriers are capab
Electronics Forum | Tue Jun 01 12:48:49 EDT 2004 | pjc
AP25 can handle warped boards to a degree. I also depends on the board clamping system on the machine. There are three avbl. First is Universal Vacuum box, second is dedicated tooling with vacuum and third is Y Snugger tooling that does not use vacuu
Electronics Forum | Thu Apr 06 18:31:27 EDT 2006 | jsloot
Any one familiar with a board clamp problem on MPM UP3000? The one I have will not clamp the board when program is running. It will work when toggled through the output diagnostics. Any help is appreciated.
Electronics Forum | Tue Jan 23 13:15:44 EST 2007 | stepheniii
Shouldn't the top of the board be at the exact same height as the top of the side clamps? Why are the clamps holding the stencil up off the board?
Electronics Forum | Mon Apr 24 09:43:47 EDT 2006 | printerman
What you describe is the X snuggers fitted into the workholder which do need either a flat board or good vacuum to work. There are several solutions. One solution you can try yourself is to use Vacuum cups, ( bellows type) designed into the workholde
Electronics Forum | Fri Feb 02 15:22:32 EST 2024 | carl_p
Machine a clamp into or from the FR4. to Tension the boards into place
