Electronics Forum | Mon Jun 30 23:05:45 EDT 2014 | gonza
Hello, new here, is there anywhere some kind of tutorial about the datacon evo 2200?
Electronics Forum | Thu Jul 31 02:40:20 EDT 2008 | JH pbf
We use Axarel 2200 as recomended by Vitronics Soltec, which is the same as we use on our MPM printes for under stencil cleaning. It is non-ozone depleating and has a high flash point. For insurance purposes we banned IPA from the shop floor some
Electronics Forum | Thu Jul 31 07:53:34 EDT 2008 | ck_the_flip
Jon, Does Axarel 2200 leave minimal residue or clumps on the wiper paper area? Also, what is your wipe frequency on a typical board?
Electronics Forum | Wed Apr 25 07:51:44 EDT 2012 | jdengler
United Chemi-Con makes a 2200uF 35V capacitor EMVA350GDA222MMN0S That's the biggest SMT capacitor I have ever encountered. Jerry
Electronics Forum | Wed Mar 21 01:19:29 EST 2001 | PeteC
We're watching more carefully at post-print and pre-reflow inspections for products with the gold finger contacts. Not 100% sure the cause. SMT line people suspect primary cause is improperly wiped stencil. Do you know any other possible causes? We g
Electronics Forum | Wed Oct 20 17:22:48 EDT 1999 | Dave F
Dunno about 310M flux, but I share your concerns about CU56. You might rethink your selection of solderability perservative, because Enthone: * CU56 allows one thermal cycle. * CU106A allows three thermal cycles. Good luck Dave F
Electronics Forum | Tue Aug 04 23:23:01 EDT 2009 | gopang
I have problem with my Panadac 770, the problem no out Put 5v, i was check : 1). Change SMPS in panadac 2). Change terminal cad 3). Change Transistor 2SC2200 4). Change transistor 2SD867 Please conform to me if have solutions and some body have wir
Electronics Forum | Mon May 03 08:09:04 EDT 2010 | Jeff
Power up your machine and look at the vision card. If it has a red light then there is a problem with it. 20k is way to much to spend to fix this. I've sent out two cards for repairs in the past and got them fixed for $2200 each. If you want more inf
Electronics Forum | Tue Jul 21 16:48:01 EDT 2020 | reckless
Each one of our panels has 2200 0402 parts and we run one panel every 3-4 minutes without any hiccups. I agree, its ancient technology to modern machines but everyone who sees it falls in love with them. Currently we are only able to run our machin
Electronics Forum | Wed Dec 13 16:40:40 EST 2000 | Bill Fluegel
I am receiving a "cognex not found" error upon bootup of a MPM AP24-X stencil printer. I have checked everything I can find between the cognex computer and the one in the machine. Has anyone experienced this before? Any ideas would be greatly appr
