Electronics Forum | Tue Nov 13 04:47:19 EST 2018 | dhammika
hi Siplace Hs-60 defected due to below error Error- • Machine error:2271 Can bus: reception call aborted with time out seg:0 DEV: head 2 #:1 (this is not only head 2 ,error raise with all head interm
Electronics Forum | Thu Sep 26 13:55:54 EDT 2019 | ttheis
One of our GSM1 machines occasionally stops running in the middle of a program and I haven't been able to figure out what is causing it. When the issue occurs, the "BM" (bus master) light on the SYS68K card drops out (turns off, no activity) the boa
Electronics Forum | Wed Dec 23 12:24:37 EST 2020 | ilavu
1. Palm down the GSM and open the safety cover to check input voltage +12VDC (at KDC2 3PL pins 2 to 3) and output voltage +5VDC (at KDC2 2PL pin 4 to 3) at the DC/DC converter. The DC/DC converter is located inside the control panel assembly ("Nose c
Electronics Forum | Wed Jun 01 22:42:50 EDT 2016 | dinhhuunam
CAN Node Not Responding This problem can be caused by either: 1. Faulty Node 2. CAN bus cable disconnected. 3. No power to CAN Node.
Electronics Forum | Mon Sep 24 19:25:42 EDT 2018 | rfazil
How can you make a cathode for selective gold plating edge connector. I know you can add bus/tie bars but we want to remove them and just want to do selective hard gold plating of gold fingers.
Electronics Forum | Tue May 27 13:27:38 EDT 2008 | tech1
Sounds like you got something stuck in the magazine bus and it blew the circuit in that lane. I think you can swap out chips on one of the computer boards in the system.
Electronics Forum | Wed Apr 29 14:02:51 EDT 1998 | Joe Hurst
>1. What are the two files that will allow you to start layout of a | | > >printed circuit board that has no Mentor Graphics schematic? | | > > | | > >2. In DA, what is a ripper? | | > > | | > >3. How do you kill a process in UNIX? | | Thanks, | | Ea
Electronics Forum | Mon May 05 13:48:42 EDT 2014 | rway
Chances are you are using this as a 2.5V voltage reference for the feedback on your regulator. One thing that isn't clear is exactly what failure you are seeing. Please specify the nature of the failure. Is your power bus out of spec? I really ca
Electronics Forum | Thu Dec 22 17:59:39 EST 2022 | emanuel
Thanks Jeff, Yes, I will be glad to know which parts you replaced, at least it will give me an idea where to start looking. I also have a feeling that being the first node, the BGE9010C if not working properly may distort the CAN Bus signal. I even t
Electronics Forum | Fri Aug 12 09:07:23 EDT 2011 | rway
The rails are being sourced by the regulators. Rails, bus, you can use them interchangeably. As far as what voltage? I have no idea other than my assumptions listed above, but more than likely you will have +/-12V and 5V. Depending on the age of t
