Electronics Forum | Thu Nov 30 22:47:54 EST 2000 | CAL
Contact Lee Whiteman @ ACI/empf. Lee is an industry expert in Leadfree soldering. He has also ran an IPC leadfree work shop involving a DOE on Leadfree Screen Printing. Lee can be reached at lwhiteman@aci-corp.org or 610-362-1200. Best regards, Cal
Electronics Forum | Thu Sep 16 03:53:04 EDT 1999 | park kyung sam
Can you imagine that there is a smt process using the a few chip and ic are nearly about 4,5,6,8 years old. Antigues?? what should you do If you are an engineer of smt process in that company. thank in advance.
Electronics Forum | Wed Sep 28 13:54:59 EDT 2005 | josephmcc
We have a Suzuki / Celmacs SMT2350 and we need the boot disk software. We are also looking for anyone who could service this machine.
Electronics Forum | Wed Jun 21 22:09:22 EDT 2006 | Nathan
Dear All, Thanks for your help. I'm not clear that when you mention the number of zones of the reflow, says 8-zones, do you refer to the total number of heater zones (both top and bottom) without cooling zone? Hi Russ, the P&P model I mentioned is
Electronics Forum | Fri Feb 04 09:17:30 EST 2005 | Steve Gregory
I have a need for two heater element/strips for the pot of a Econopak EPK+ Type 400F. PN 3-0606-793-01-2. I was told it would be 2-3 weeks from Electrovert. If anybody knows of where I might get them quicker than 2-3 weeks, I sure would appreciate it
Electronics Forum | Mon Jun 19 22:19:40 EDT 2006 | Nathan
Dear All, We plan to setup an assembly line for our small volume production of PCBs (about couple hundred PCBs per week). The board has about 150 components (less than 30 types) and a few BGA and IC (majority is SMT, only few THT connectors). We hav
Electronics Forum | Thu Sep 16 05:37:18 EDT 1999 | Earl Moon
| Can you imagine that there is a smt process using the a few chip and ic are nearly about 4,5,6,8 years old. | Antigues?? | what should you do If you are an engineer of smt process in that company. | | | | thank in advance. | | I'm s
Electronics Forum | Wed Jun 21 13:06:13 EDT 2006 | Nathan
Dear All, Thank you very much for your advices and comments. I appreciate that. Does anyone have any idea how much the good working condition second hand MY9 will cost? And how does MY9 compare to SMT 2350C in term of cost and performance? Regardin
| 1 |
