144 242 results

Electronics Forum: 242 (Page 1 of 15)

QP 242

Electronics Forum | Thu Mar 10 06:16:37 EST 2011 | ravo

I am asking if I can assemble BGA components with my machine QP242. My BGA spec : WIDTH * LENGTH = 27*27 MM PIN DIAMETE = 0.6 MM Thankd in advance.

QP 242

Electronics Forum | Mon Mar 14 12:49:28 EDT 2011 | cvoyles

The QP242 is a modular placer. If you have the BS (single head)module with the MTU7 tray unit you can most definitely place this device. If you have the BI units with no tray tower it is doubtful.

QP 242

Electronics Forum | Tue Mar 29 04:25:06 EDT 2011 | smellew

Hi 1st, Please find attached BGA manual this may help you, regards llew

QP 242

Electronics Forum | Tue Mar 15 10:14:43 EDT 2011 | cyber_wolf

Yes and no. If you are going to just look at the body of the part then yes. If you are going to look at the balls then probably not. People will tell you that the QP will recognize balls which maybe true to some extent, but it will not do it over an

QP 242

Electronics Forum | Mon Mar 28 17:25:32 EDT 2011 | smellew

revola, Yes you can as long as you have a type 4 or 7 line scan camera fitted(type 7 is best as improved lighting), Front or Rear loading is not important, Snr tech is right, lighting isn't great with this machine but the camera is the same as fitted

QP 242

Electronics Forum | Tue Mar 29 04:15:01 EDT 2011 | ravo

Dear All, Thank you so much for your cooperation. Actually am in continous problems with my BGA and can not assemble it using my QP242 till now, I am using the following data : Vision no. : 1 Vision Type: 230 Height: 2.32 Body Size X: 27.00 +-0.

QP 242 yellow vinyl decal back light for nozzles

Electronics Forum | Wed Aug 02 23:38:47 EDT 2017 | tlake1974

Dose anyone know where to purchase the yellow vinyl decal material by the roll uncut used on the FUJI QP 242 back disk? Any info would be appreciated.