Electronics Forum | Wed Mar 07 14:42:46 EST 2001 | Sunil Grover
Check the wave of each category ( ex. input , output ) . => Check these wave is in each tolerance or not . If you can forward to others who know, that would be helpful. Sunil Grover 408-245-9264x135 (O) 408-245-9284 (F)
Electronics Forum | Thu Oct 11 06:09:50 EDT 2018 | mk15
hello, Does anyone know about the error F-MOT-MOVE X/245 Motor drive inhibited. The machine hardware initiation ready and approximately an hour later, you will see an error. Thanks
Electronics Forum | Wed Dec 20 11:02:05 EST 2000 | LarryK
Does anyone know the terms or keywords for the following? PIH ECA CCA Thanks Larry
Electronics Forum | Tue Dec 26 11:36:08 EST 2000 | acahill
PIH, I think this stands for, Paste In Hole. (Intrusive reflow) ECA, ? CCA, ?
Electronics Forum | Thu Nov 04 12:41:37 EST 2004 | cobar
Definetely 245�C
Electronics Forum | Thu Jan 31 06:38:55 EST 2008 | cobar
Wave too high,pot temp to high set to 245�C. Solder level too low.
Electronics Forum | Mon Oct 25 11:20:52 EDT 2021 | bk
The 245 error is with your x belt motor not the x wagon motor. double check all the fuses on the back of the machine where your power comes in there should be 3 of them. if you haven't changed your blue cables in a while I would change those out. you
Electronics Forum | Tue Nov 29 12:16:29 EST 2005 | Inds
MKS, You do not need to reach a temp of 245C to form a joint and surely not for 0603s. Since you are using such a high temp your flux is getting dried out.. Also if you are going to reach a peak of 245C on a brd that has Sn/Pb compt and Pb-free.. yo
Electronics Forum | Sun Oct 24 08:07:06 EDT 2021 | artem
Hello, I have a Mydata TP11-UFP which stopped working. It prints F-MOT1-38/245:MSETDYNX during initialisation. Any idea what could be wrong? I have already replaced the capacitors and the Inrush Current Limiters on the "L-19-588-18" board. Also ins
Electronics Forum | Wed Dec 20 11:55:29 EST 2000 | Chris May
Larry, A bit of a puzzler How about PIH = Pin In Hole As for the other two, they are not something that I have come across and immediately recognise. What are they in relation too ?? Regards, Chris May