Electronics Forum | Tue Apr 27 13:01:03 EDT 2021 | procyon
Looking to repurpose some older 32mm GSM Blue Label feeders for a custom application. These feeders are the 24V type and not 42V. Does anyone have any information on connecting to and communicating with the feeder outside of a GSM machine or setu
Electronics Forum | Wed Apr 09 03:32:49 EDT 2014 | sarason
Place a Digital CRO on that 24V rail. Watch the output. trigger on voltage drop lets say 18V picking a figure out of the air. You may well have another rail in your supply or nearby pulling your 240V //110V rail. Most likely a shot Electro either on
Electronics Forum | Thu Apr 16 05:50:25 EDT 2015 | sarason
Do you mean a 24V Linear Actuator ? sarason
Electronics Forum | Fri Oct 26 09:43:19 EDT 2018 | dnachristen
Hello! A member here graciously sent me the pinout I needed. I now have 24v to the feeder in the test rig, but need to know what type of signal the feeder requires on pin 9 to electronically index. Anyone have a clue? I tried ground signal and 24v, n
Electronics Forum | Fri Sep 04 11:36:42 EDT 2020 | inspiredmorris20
!!UPDATE!! We have found the issue, power supply #3 was bad. The PSU was not sending 24v to the emergency system which is normally a closed circuit. Being that the emergency system was not getting the 24v it assumed the e-stop had been depressed. T
Electronics Forum | Sat Feb 13 08:03:14 EST 2021 | dilogic
I might answer some of your questions: 1 - in order to use old 24V feeders, Advantis needs 24V feeder kit installed. As far as I figured out, it's only 24V transformer and wiring, so I guess you can do it yourselves if the machine is not upgraded
Electronics Forum | Mon Oct 16 16:05:59 EDT 2000 | CAL
Brian- IPC has SMEMA Down loads for communication protocal: http://www.ipc.org/html/fsresources.htm. Also, I interfaced a fuji CP6 with a Siemens s20 and had to put in a relay and sensor to complete the communications loop. Fuji uses a 24v on/off com
Electronics Forum | Thu Apr 11 21:20:04 EDT 2013 | dman97
Hello. I am having a problem with a CP3 machine. This machine decides every so often to kill 24v power to its self. At first I thought it was a bad 24V power supply, but I swapped it out and it still decides to occasionally kill its self. I also re
Electronics Forum | Wed Apr 28 15:18:17 EDT 2021 | dilogic
24V feeders are very simple to interface. You have supply voltages (24VAC, 12VDC), status output and control input (advance). All signals are using 12V levels. To advance feeder pull control input to GND. Connect status output to +12V with a pull-up
Electronics Forum | Wed May 03 13:35:00 EDT 2023 | ttheis
Thanks, Deni! We're replacing two 4-spindle GSM's with two GX-11S with Flex3 front and IL4 in the rear. These we plan to use a mix of our pneumatic & 24V feeders as well as high speed feeders as we acquire them. The sellers advised that the 24V kits
winsouce.jpg)