Electronics Forum | Wed Mar 19 09:37:04 EDT 2014 | felo188
Hi all, I'm looking for mother board to reflow oven (ERSA 250). Serial number: ERSA 6EBG011-3 SC-ERSA ERS250 Regards
Electronics Forum | Tue Dec 21 20:05:01 EST 1999 | Chris
Try Flip Chip Technologys. They have several daisy chain flip chips. One is called FP250. .250 X .250 solder bumped flip chip. Try Technet too. Remember seeing several other manufactures of daisy chain die. Maybe Unitive at www.unitive.com can
Electronics Forum | Mon Nov 26 14:48:43 EST 2001 | PeteC
The tooling fixture has tooling pins to accomidate your PCBs. Typical PCB tooling holes are 0.125" dia. non-plated thru holes and 0.250"x0.250" from the edge of the PCB. Check out this link to EMC Global Technologies. They mfg. tooling fixtures for U
Electronics Forum | Wed Jan 09 06:37:04 EST 2002 | renocassar
I was contacted in order to set up a factory in order to produce home and car alarms equipment. I wish to use a fully automatic SMT line. That is I want a pcb unloader, glue dispenser, conveyers, Pick and Place machine and unloader. The maximum board
Electronics Forum | Thu Jun 07 05:11:42 EDT 2012 | cp38260
Hi, I have pcbs (Duroid/RT 5880) with raw copper, soldered in vapour-phase chamber at 230 degrees Celsius. During soldering, copper gets tarnished. Cleaning with Vigon A250 removes the tarnished layer. Indeed, in the VigonA250 techn. datasheet it is
Electronics Forum | Tue Nov 23 16:59:32 EST 2004 | Terrapin Station
At 30 seconds each feeder change = 30 min x 4 times each day. that is 2 hours. Based on 5 days each week x 50 weeks, you have 250 working days (do not know how many holidays you have). 250 working days x 4 hours =1000 hrs. How much does each hour of
Electronics Forum | Wed Sep 08 01:10:30 EDT 2004 | alan
We have an issue with our Seho Wave solder machine. The machine is an 8040C, early 90's model. The problem is that continues to heat the solder up, even once it has reached its specified temp. If we set it for 250 degrees, it will go to 250 then c
Electronics Forum | Sat Dec 15 06:34:54 EST 2012 | sowmya
Normally paste manufacturer specifies stencil life of a paste is 10 hours. the question is, if i run a continuous manufacturing for 40 hours, we will be adding 250 g of paste for every two hours. The addition of 250 g will be mixed with the paste whi
Electronics Forum | Tue May 24 18:00:42 EDT 2005 | davef
Pellet Fuels Institute; 1601 N. Kent Street, Suite 1001, Arlington, VA 22209; 703-522-6778 Fax 703-522-0548 pfimail@pelletheat.org http://www.pelletheat.org Pellet Fuels Institute represents the fuel preparation and clean burning technology of
Electronics Forum | Wed Jul 18 08:00:48 EDT 2001 | davef
250C flass transition temperature - M = coloring agent or opacifier added to F resin with 110-150C glass transition temperature - N = natural color of resin - P = coloring agent or opacifier added to resin - T = natural color F resin blended with
.jpg)
