Electronics Forum | Wed Dec 07 14:20:29 EST 2005 | Robert
I had a DEK 265LT with error code: motor comms failure.card 1, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 1 and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, Rober
Electronics Forum | Thu Sep 22 20:52:08 EDT 2011 | dekhead
Low DCV on batteries should not cause issue with MINT download, but will cause loss of MINT files (and necessitate reload) upon power down... Please contact me for additional assistance. http://www.dekhead.com
Electronics Forum | Tue Mar 20 09:25:35 EDT 2012 | dekhead
If problem is jumping from card to card; my direction would be 5vdc level. generally like it to be min of 5.15vdc on the MINT cards (top lead of 7-segment display). www.dekhead.com
Electronics Forum | Mon Nov 09 15:44:39 EST 2020 | mikewschomisch
DEK 265LT displays CMOC is BAD: Restoring from EEPROM.... EEPROM is BAD: No Restore was made. You MUST run SETUP followed by LOCKMOS... FAILED Any help appreciated.
Electronics Forum | Tue Nov 20 19:09:04 EST 2018 | dekhead
Island SMT showing in stock. http://islandsmt.com/product/front-and-back-stencil-sensor
Electronics Forum | Fri Apr 29 22:35:01 EDT 2016 | dekhead
Pneumatic failure is a good guess, as GSX/LT are renowned for their leaky airlines. However on this I would doubt, since the Board stop is a single throw pneumatic with a spring to retract. The return spring broken / disconnected is certainly a possi
Electronics Forum | Fri Jul 26 16:40:35 EDT 2019 | mdemerse1
http://islandsmt.com/wp-content/uploads/2017/02/Dek-265GSX-User-Manual.pdf"" target="_blank">http://islandsmt.com/wp-content/uploads/2017/02/Dek-265GSX-User-Manual.pdf"" target="_blank">http://islandsmt.com/wp-cont
Electronics Forum | Mon Jul 30 17:31:59 EDT 2018 | dekhead
That error message is keyed by a hardware (soldered) link on the backplane board of the Y1 (motor controls), through direct cable to PCIB40#3... check connections both ehds; possibility of multiple PCIB failures?
Electronics Forum | Mon Jul 30 11:05:57 EDT 2018 | dekhead
Failure on PCIB40#3; try swap with PCIB40#5. Will need to change addressing (jumpers or rotary SW).
Electronics Forum | Sun Mar 07 21:26:54 EST 1999 | Chris G.
| My printer evaluation has come down to the Fuji GP-6 or the Dek 265LT. I'm looking for experienced opinions on both of these options, we're currently running an older vintage Dek 265 printer that gives us constant electronic system problems. The v
