44 268 tool bank results

Electronics Forum: 268 tool bank (Page 1 of 5)

Mydata TP9-UFP problem - Can't reach tool bank

Electronics Forum | Mon Oct 22 16:33:14 EDT 2018 | tey422

To narrow down the cause. Have you test it on all your tools? If only particular tool(s) having issue, then it might be tool that's having the problem.

Mydata TP9-UFP problem - Can't reach tool bank

Electronics Forum | Tue Oct 23 00:52:16 EDT 2018 | filipblad

Yes, for all tools... The tool head stops just above the tool

Mydata TP9-UFP problem - Can't reach tool bank

Electronics Forum | Mon Oct 22 08:27:49 EDT 2018 | filipblad

Hi, We're having issues with our mydata tp9 pick'n place. It doesn't go all the way down on the tool, so it can't pick it up or install it. The fault code I get when trying to install tools is F-TLMN-18: Can't reach tool bank. Any ideas? I've comp

Mydata TP9-UFP problem - Can't reach tool bank

Electronics Forum | Wed Oct 24 00:36:59 EDT 2018 | filipblad

I've checked the locks in the service program and the solenoids move when told to.. also I can see them opening when going to pick up a tool..

Mydata TP9-UFP problem - Can't reach tool bank

Electronics Forum | Wed Oct 24 10:02:17 EDT 2018 | tech1

That error points to a hardware issue. When it fails does it ask you to insert a tool manually?

Mydata TP9-UFP problem - Can't reach tool bank

Electronics Forum | Tue Oct 23 11:18:23 EDT 2018 | tech1

It is probably one of the Z lock solenoids not working properly. These are located along the Z axis and as part of the initiation of the machine, the Z measure the travel. Check the upper and lower Z locks

Mydata TP9-UFP problem - Can't reach tool bank

Electronics Forum | Wed Oct 24 07:33:44 EDT 2018 | tech1

when the machine initiates the last move it does is in the Z axis. If memory serves me, during the last Z move it drives down and measures the stroke, if the lower solenoid is not fully retracted the axis measures the wrong travel limits. Hopefully t