Electronics Forum | Wed Feb 14 16:45:01 EST 2001 | Antonio
I'm sorry, I should clarify. The average is one out of six boards. It's not consistant as to how many are good before a really bad one. Sometimes two in a row, sometimes ten. Right now we are wiping every 2 boards. Antonio
Electronics Forum | Tue Jan 13 07:44:48 EST 2004 | Chris Cottreau
Upon inspection were seeing most if not all of these SOT 23 are not reflowed properly. The components just sit on top of the solder, this is creating insufficients, poor wetting, etc. There are about 25 SOTS per board, 2 boards per panel creating alo
Electronics Forum | Mon Jun 12 14:33:40 EDT 2006 | pjc
IPC spec is V-score shall not be more than 1/2 board thickness. They should be V scoring 1/4 off top and 1/4 off bottom equally.
Electronics Forum | Mon Mar 12 07:48:45 EDT 2007 | Rob
Hi Himanshu, if you go to http://www.icmaster.com and type in CXA1619M, you will get the full data sheet, which includes 2 applications circuits and 2 board layouts. Please note that this is an old product. Good luck, Kind regards, Rob.
Electronics Forum | Wed Nov 23 09:22:16 EST 2016 | hloranzo
on the quad Qsv1 plus the z1 board has a amber light not green ,,, swap the z2 board and still amber light help please
Electronics Forum | Wed Nov 23 10:02:57 EST 2016 | hloranzo
on the quad Qsv1 plus the z1 board has a amber light not green ,,, swap the z2 board and still amber light help please gantry Z1 movement failure
Electronics Forum | Wed Mar 04 14:32:21 EST 2020 | bk
The mot mi board is the first board but it is two boards tied together so you need to undo the screws on the first 2 boards on the left.
Electronics Forum | Wed Jan 06 11:05:13 EST 2021 | greezmky
Thank you rtmitchell, being unfamiliar with the system, I missed that the end is slightly nicked. I pulled a dog out of a machine that has been cannibalized, I verified that it was straight and not nicked, and installed it in our production line mach
Electronics Forum | Thu May 09 10:00:19 EDT 2002 | brianockert
I'd tend to agree with what the others have said. Check the basics, board supports, setup, wiper paper working correctly. If it's a humidity issue, try taking some paste, place it on a chem wipe, and roll it around a bit, which removes some of the mo
Electronics Forum | Wed Aug 26 15:00:08 EDT 2020 | jmelson
That's a rev 1 board, my machine has a rev 2. I have no idea if they are interchangeable. So, I bought a Rev 2 board from Korea. But, I'm flying pretty blind on this. I have traced the ready button signal to a microprocessor pin on the IO_DPRAM bo