Electronics Forum | Mon Nov 12 09:37:17 EST 2007 | russ
You need to perform process a capability study prior to putting these controls into place. Cleaning a stencil after each pass will get ugly, solvent residues remaining in apertures etc. 2D inspection is good. Change paste every hour will get very
Electronics Forum | Mon May 14 03:21:20 EDT 2001 | Eyal Duzy
Phil, In the considerations you make for choosing an AOI tool, you should check what a vendor delivers today and what will it be able to deliver in the future. As the role of AOI in the SMT production line evolves from "detection" to "prevention"
Electronics Forum | Fri Mar 12 19:09:21 EST 1999 | Jess Baker
Manufacturers who have to mark barcodes onto PCB's without secondary application of pressure sensitive labels can etch it on, screen it on, inkjet it on, use laser marking, or a combination of those. Using a laser marker to write a code into a label
Electronics Forum | Tue Jan 12 19:07:07 EST 1999 | Earl Moon
| | For process management with SPC of the stencil printing process with a fully automatic stencil printer, what process outpur parameter would you recommend for SPC? | | | | It appears to me that there are two options: | | A: to have a pn chart bas
Electronics Forum | Fri Nov 23 14:47:35 EST 2001 | kgroen
Some comments on the previous post: Be careful when looking at the proportion of SMT defects that are solder defects - you may very well find that only a small few of them originate at the screen printing step. As for specification limits for pas
Electronics Forum | Thu Oct 17 17:18:48 EDT 2002 | Leandro G. Barajas
Hi everybody, This is a simple posting to initiate a discussion on different ways to troubleshoot, improve, and control the Stencil Printing Process SPP in SMT manufacturing. There are many SPC, ANOVA and other analysis techniques that provide insi
Electronics Forum | Wed Jun 18 19:26:39 EDT 2003 | gregoryyork
Rules of thumb :- 1. Never over flux - not necessary and waste's money. Never top flux neither 2. Top Board temp. around 70C - 105C or there about's pending what laminate you use. Obviously the more flux you apply the higher heat required/denser PC
Electronics Forum | Tue May 08 11:27:49 EDT 2001 | Eyal Duzy
I will review some of the advantages/disadvantages of AOI vs. X-Ray one by one according to the main differences that you may find between them. * AOI uses optics that can "see" only visible elements. X-Ray can "see" hidden elements. There is a ve
Electronics Forum | Mon May 14 09:43:37 EDT 2001 | orbotech
As the face of business changes through revolutionary factors, such as the increasing rate of outsourcing, manufacturers (especially EMS plants) will strive to fine tune their test strategies to ultimately improve and sustain product quality and to r
Electronics Forum | Sun Aug 28 23:53:58 EDT 2016 | aemery
I don't think there is a camera off message in the software, but I might be wrong. So I am making a bit of an assumption here that you didn't have a displayed image and your error was a fiducial not found error. I am also wondering if you decided to
