Electronics Forum | Sun Nov 10 14:17:40 EST 2002 | anonname457
We just went through the same comparison shopping for our company -- and we ended up choosing Juki machines -- as our comparison was between a MY9 with a hydra head and the Juki 2010 & 2020 combo. Both machines have excellent software packages and ar
Electronics Forum | Thu Oct 14 12:42:59 EDT 2010 | remullis
Universal makes great conveyors as well. The loader/unloaders can be configured to input boards to the line or buffer them. I actually found a 22" piece on ebay a couple of years ago for 300.00. Worked great!
Electronics Forum | Thu Jan 21 07:03:43 EST 2016 | anel_elektronik
I have it: "Inline Before Input" have to be closed. Conveyor Board CP35. Greetings
Electronics Forum | Thu Dec 07 15:23:21 EST 2017 | emeto
Is that a 3 stage conveyor or a single stage? If it is a single stage, your sensor doesn't work, because your motor is already turning. If the input stage is separate you have two options - sensor or motor. Just check them both for proper functioning
Electronics Forum | Fri Mar 24 08:10:12 EST 2006 | mapell
Hi AR Nice job on the chain/rail cleaning. I would contact Speedline Electrovert tech support, 800.737.8110 to assist in trouble shooting. They can walk you through using a meter to measure input and output current to the SC card and make sure tha
Electronics Forum | Tue Mar 28 04:49:39 EST 2006 | AR
All's well that end's well: I replaced the Dart speed controller card and the problem disappeared completely. But no harm in giving the chains and the rails a thorough scrub although they weren't the culprit in this case. Many thanks to everyone for
Electronics Forum | Tue Oct 09 20:30:25 EDT 2001 | djarvis
Thank you all for your input. We didn't get the oven and if we did I decided in the short term to just turn it around and run it as a belt mesh oven - the next line we buy runs it's conveyor to suit the oven. Hi to you Marc, it's been a few years. Yo
Electronics Forum | Sat Dec 08 22:44:59 EST 2018 | youngbuck
Hi, Was wondering if anybody has any experience with F5 with the conveyors will work sporadically. If I put a board on the input sensor in which it sees it will work, the next 5 minutes it won't work. Could this relate to the K2 relay, if so does any
Electronics Forum | Tue Sep 01 11:12:18 EDT 2015 | zombee
Problem is solved! There wasn't voltage on motor inputs (only 5-10V AC) when the motor connected correctly, but was ~210V AC without motor. Firstly, I exchanged the motor speed control relay (Panasonic G-series type), but the result was same. (the a
Electronics Forum | Fri Oct 13 12:43:40 EDT 2000 | Brian
Can anyone help? We have reconfigured our production lines and I could use some help for machine communications on 2 production lines. Does anyone know how to get a handshake for the following equipment? Asm Line #1)UIC 4713D output to input Fuji