Electronics Forum | Fri Mar 26 23:07:07 EDT 2010 | dekhead
Just a guess: Are you printing your fiducials on the fiducial side of the board? Fidicial Side is for Vision Calibration, Bare Copper Side is for Offset Calibration (Step 5 of procedure says "copper side uppermost"). After printing 25 fiducials o
Electronics Forum | Wed Jun 19 10:49:00 EDT 2019 | jamesn
Thanks Bob for the speedy reply I will check these out and let you know Kind Regards James
Electronics Forum | Wed Jun 19 10:11:59 EDT 2019 | jamesn
Hi to everyone I hope someone can help me with a problem I have on a Quad QSP-2. when calibrating ( Or trying to use ) Feeder Bases 2 and 4 on gantry 2 Im getting small amounts of accumulative drift in the X axis. I have changed the servo amplifier
Electronics Forum | Wed Jun 19 10:40:07 EDT 2019 | bobpan
The only thing left is the read head. Older read heads tend to 'weaken' with age. Sometimes some engineers will shim them up closer to the scale using a 10 mil shim. You could also swap them between gantries...i dont think they are to tough to get to
Electronics Forum | Wed Jun 13 10:29:54 EDT 2012 | markhoch
Is anybody using the Argos Systems FVS2 FeederVision Station? It's half the cost of the ASM (Siemens) system, and appears to do more.
Electronics Forum | Fri Jan 31 11:45:52 EST 2014 | emeto
Hi, to get better image you will probably need higher voltage(depending on how close you want to look). The closer you get the higher the voltage should be. Here are some tips for machine calibration: 1. Make sure your board is on focus. I don't kn
Electronics Forum | Tue Aug 17 08:36:01 EDT 2004 | rlackey
CP6/7 feeders are mechanical indexing machines, and the springs, cams etc wear over time leading to misfeeds & increased attrition. You can just strip & repair but especially on the 8x2 feeders the pick up position is critical. John, I'd check with
Electronics Forum | Fri Feb 22 13:24:24 EST 2008 | mulder0990
How did I know senior was going to get in here too. Nice to see you again. I figured as much with the height difference, but I do not have the equipment here to test my thoughts. We somehow have our machine dialed in to run the 0201 parts with W
Electronics Forum | Sat Jun 05 08:18:03 EDT 2004 | vinitverma
Hi Grant, If you're really looking for speed, I'm sure you're looking for another machine for doing the QFPs, BGAs stuff etc. In that even, why not have a look at the long proven Assembleon FCM machine!! It is a totally different concept with UNMATC
Electronics Forum | Wed Feb 05 08:51:13 EST 2014 | emeto
What I think it does is to calibrate the camera. You have your tube on the bottom and your camera on the top. For my machine(Dage) I have to put the board I am going to examine inside and select a point on the board surface. THen I just click on this
| 1 |
