Electronics Forum | Thu Aug 18 11:38:34 EDT 2011 | johndoe0222
I got this error message on the fuji IP3: " Servo limit over. Servo Z1 Axis +" I was wondering how to fix this error. Thanks.
Electronics Forum | Sat Apr 04 03:24:41 EDT 2009 | monduran
Our company is in the market to replace the $50 toaster oven we use to reflow boards with something that can actually achieve even temperature and a proper reflow curve. We are a RnD type company and have no need for volumes. Though we have some heav
Electronics Forum | Fri Jun 19 15:17:54 EDT 1998 | Chris Jackson
We are in the process of validating Silicon 1C55 (thermal cure) conformal coating over Alpha LR725 solder paste. I am looking for anyone who may be using this process, or has been exposed to someone who is doing this process. Our concern is with the
Electronics Forum | Tue Jan 24 21:15:07 EST 2017 | david_chiu
I have met the same issue before. 1st possible root cause: The dimensions of reel's each chip inserting hole are a little bigger. You need to see if the turn over issue are all happened in the same vendor's reel material. 2nd possible root cause: The
Electronics Forum | Fri Feb 15 08:33:59 EST 2002 | fmonette
The joint IPC/JEDEC standard currently specifies a limit of one bake cycle, regardless of the temprature or duration. In the proposed revision this will be replaced by a maximum cumulative duration of 48 hours at 125C. The reason identified for thi
Electronics Forum | Tue May 22 02:21:12 EDT 2018 | robl
Hi Reckless, We've had machines from all over the world off it, just need to keep an eye and move fast. Had quite a bit from USA over the years, also Korea, Scandinavia, Germany. Good deals don't tend to hang around. Rob.
Electronics Forum | Fri Jun 12 11:19:25 EDT 2009 | gregcr
we have a small heller 988 oven that has served us very well over the years. I see them cheap on the used market. Worth looking into in my opinion.
Electronics Forum | Sat May 19 13:22:42 EDT 2018 | reckless
Are there any other good websites to shop for pick and place machines? Preferably not dealers who are over charging for machines
Electronics Forum | Mon May 21 03:54:44 EDT 2018 | robl
Yep, we've had good kit off of Equipmatching.com and this site before, direct from users. Also speak to the manufacturers official distributors as they often look to shift old kit when they are putting in new. Sometimes you have to work hard for
Electronics Forum | Tue Oct 14 10:52:35 EDT 2014 | swag
Can't help you with the manual but do have some tips: If it was shipped, it's possible someone tied axis or blocked stuff for shipping. Look for that. Look for bent sensor flags + go into I/O and check to see all sensors you can find are working.
