Electronics Forum | Tue Mar 05 22:34:27 EST 2002 | YoYo
You better be careful how you plug vias at screenprint - we currently have a customer that wants vias plugged, so we had a 2% aperature reduction so we would not have to much paste, I believe it should have been reduced more because some of the solde
Electronics Forum | Thu Apr 27 11:50:21 EDT 2006 | samir
90% of the battle with thermal profiling is your thermocouple attachment. That is Process Engineering 101. It's just like painting your house. The masking and prep work will make or break the end result. KIC did a DoE on which thermocouple attach
Electronics Forum | Tue Aug 11 09:52:53 EDT 2015 | rgduval
I assume that these parts are falling off during second-side reflow? The easy solution, of course, is to not build high-mass components on first-side reflow. If this isn't practical, however, you can try using epoxy/glue under the component. We'
Electronics Forum | Tue Mar 27 01:52:23 EDT 2018 | buckcho
Hello Diego, are the components missing on the first side or the second side. Like Mr. Evtimov said, you can check before the oven the pcbs's visually and see what happens after the oven. In this way you can see if it is the oven for sure. Then there
Electronics Forum | Fri Mar 02 09:08:25 EST 2007 | samir
There is a formula that determines whether a component will fall off during a 2nd reflow. It takes into account the grams (weight) of the component and the total surface area of the solder joints. I don't know this off the top of my head, but it's
Electronics Forum | Mon Jun 30 10:02:37 EDT 2003 | Steve Gregory
Hi Russ! An "R" QFP is what Altera calls their Plastic Quad Flatpacks that have a heatsink in the top...they actually call them Power Quad Flatpacks. I'm familiar with the formula, of how one can figure out if there's enough surface tension for a p
Electronics Forum | Mon Aug 14 03:38:37 EDT 2017 | spoiltforchoice
The pads in the datasheet should suffice. The TDK part really isn't all that big but its reflow profile indicates it is not exactly the most tolerant device with regards to heat. 245C for 5s is not a lot, I would check very carefully that your profil
Electronics Forum | Thu Jul 20 17:01:26 EDT 2000 | Bob Willis
Here is some further information on SDSRS process, but please purchase a copy of the report from t he SMTA as all the money goes to charity. In the UK the SMART Group raised over �3000 for the homeless. SMTA have been raising a lot of money for the G
Electronics Forum | Thu Mar 15 12:33:50 EDT 2007 | ck_the_flip
To do a profile at most companies, if you don't have a scrap board handy, you'll use the already-soldered board that's already been through ONE reflow cycle. You spend time attaching T/C's with the aluminum tape - after all, the prep-work is half th
Electronics Forum | Tue Dec 11 09:46:58 EST 2018 | davef
What is the difference of the components that fall and the ones that don't fall?