Electronics Forum | Fri Nov 08 17:20:52 EST 2002 | davef
You need to get as much paste on the board as you can get. A BIG opening gives: * Better release. * More paste. You may be able to cheat further by rotating the square so that it is on the diagonal.
Electronics Forum | Tue May 27 17:09:46 EDT 2003 | davef
J-STD-001C, Table 11-1 is a good starting point.
Electronics Forum | Sat Nov 11 07:54:53 EST 2006 | davef
Many use the following guideline when judging the proper paste for a stencil aperature: You want approximately 5 particles minimum across the smallest aperture.
Electronics Forum | Wed May 26 11:16:03 EDT 2010 | cyber_wolf
It is totally normal for these solenoids to run very hot. Hot enough to fry spit. I wouldnt pay any attention to it
Electronics Forum | Tue Jul 23 15:41:31 EDT 2002 | habs24
Does anyone have any information or experience soldering of class 3 products with WS fluxes. We are currently leaning toward Alpha WS609 flux, however the customer's interpretation of J-Std-001C feels that type 'H' fluxes (WS) are not allowed. Any
Electronics Forum | Wed Jan 26 05:24:56 EST 2005 | SLVito
Morning All, I have to choice between two axial through hole machines: Panasert AVK 3 and Universal VCD Sequencer 8. I will insert axial components with 0,45 mm to 0,8 mm component lead diameter and perform jumper wire insertion in the same machine.
Electronics Forum | Wed May 06 17:41:07 EDT 2009 | wbaldwin
We seem to get "internal Error" crashes everytime we change programs on the series 3 Agilent SJ-50 AOI machines, as well as random crashes during inspection. Was just wondering if any other users out there are experiencing the same things, and if th
Electronics Forum | Wed May 26 04:46:13 EDT 2010 | mmjm_1099
ALl - I need some feedback why a solenoid on station 3 is getting excessively hot. I have another line with the same setup but is not getting as hot. I have tested out voltage and see nothing that is triggering me there is an overvoltage. Any feedbac
Electronics Forum | Wed Jul 07 11:40:32 EDT 2010 | daxman
Huh... Can you maybe explain a bit more? Are you getting this error on the IP3 monitor or on the programming computer? Do you use MCS, Fuji Cam or Flexa? Will the machine start up and zero-set? At which point of the power-up does the error arise? Are
Electronics Forum | Fri Oct 23 10:21:45 EDT 2015 | kurtiss
During production the machine Cycle Alarm ESC 3. When cycling power the error shows up again during a zero set after performing the Z1 zero set. When it errors out on zero set the only option that the machine allows is to power off. Thanks in advance
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835