Electronics Forum | Mon Aug 10 16:35:09 EDT 2020 | kumarb
http://www.smtwenzhan.com https://smtwenzhan.alibaba.com Email/Skype: smtwenzhan@163.com">smtwenzhan@163.com Tel/Wechat/Whatsapp: +86 13923713803 QQ: 2966592980 Add: 3F. Building D, Lihao Yongda Park, No.20 Dongfang Blvd, Matian, Guangming Dis
Electronics Forum | Fri Jan 28 15:22:07 EST 2011 | dougt
The PLC240-AK is an IC on the stepper board used to control all the stepper driven axis. I don't remember which axis are driven by stepper motors, possibly the table (x axis). Which axis acts wierd or doesn't move when you home the machine?
Electronics Forum | Thu Nov 10 11:48:03 EST 2016 | awhite
I recently had a similar problem on our 2000Hie, although ours was a 7-Hardware, Vision X. Turns out there was a short/break in the 3-wire harness that controls the Vision X Stepper. The difficulty came from the fact that this particular harness is
Electronics Forum | Wed Feb 04 23:27:38 EST 2004 | dougt
I did some work with 400E's and have can give you a couple things to try with your Y axis problem. 1. There is a file called stepperparms.exe that will load all the stepper parameters on the PCL IC's. Your y axix chip may have corrupt data on it.
Electronics Forum | Tue Jun 10 18:44:48 EDT 2008 | adamcrum
Were dealing with firmware issues for the stepper motor, as well as communications problems with the software. Vitronics is looking into it... again, but even they seemed to be stumped. You may want to ask your rep about it. Our machine is brand new,
Electronics Forum | Wed Jul 11 14:18:04 EDT 2007 | fredericksr
1) We have been using the replacement tips regularly. We, also, purchased a precision pin gauge that we are using to clear the C14 nozzle without risk of stripping it out. 2) Right. However I've pinned the 0402 centering level down at -25um.
Electronics Forum | Thu Aug 08 18:21:21 EDT 2019 | Aaron
I recently purchased a contact systems 3, and 3s, and 4 of their 3zs. they were all used in various states of working. supposedly one 3s and 3z were working when taken out of service and had sat for a few months. another 3z had a homing issues and th
Electronics Forum | Tue Feb 24 16:57:03 EST 1998 | henry
EQUIPMENT FOR SALE QUAD 100 V3/V6 Low hours, Excellent condition, All latest factory revisions Firmware 3.65 Central controller software 5.6D with computer system Autoprogram software 5.31 1- 28" Latching feeder base 5- 4" Latching feeder b
Electronics Forum | Sat May 28 19:54:20 EDT 2005 | MikeaJ
I agree with Ken, the root cause could very well be obvious. However, take a look at the following items, these checks only take a minute to accomplish. 1. If your stepper drivers are the older 5410 Pac Sci modules, check for melted power connectors
Electronics Forum | Thu Jul 17 10:09:06 EDT 2008 | dfhoadle
Were dealing with firmware issues for the stepper > motor, as well as communications problems with > the software. Vitronics is looking into it... > again, but even they seemed to be stumped. You > may want to ask your rep about it. Our machine i
