Electronics Forum: 3 stepper (Page 1 of 2)

MPM 2000

Electronics Forum | Thu Nov 10 11:48:03 EST 2016 | awhite

I recently had a similar problem on our 2000Hie, although ours was a 7-Hardware, Vision X. Turns out there was a short/break in the 3-wire harness that controls the Vision X Stepper. The difficulty came from the fact that this particular harness is

Contact System CS-400 E problems

Electronics Forum | Wed Feb 04 23:27:38 EST 2004 | dougt

I did some work with 400E's and have can give you a couple things to try with your Y axis problem. 1. There is a file called stepperparms.exe that will load all the stepper parameters on the PCL IC's. Your y axix chip may have corrupt data on it.

Vitronics Delta 5

Electronics Forum | Tue Jun 10 18:44:48 EDT 2008 | adamcrum

Were dealing with firmware issues for the stepper motor, as well as communications problems with the software. Vitronics is looking into it... again, but even they seemed to be stumped. You may want to ask your rep about it. Our machine is brand new,

MyData Missing Placements

Electronics Forum | Wed Jul 11 14:18:04 EDT 2007 | fredericksr

1) We have been using the replacement tips regularly. We, also, purchased a precision pin gauge that we are using to clear the C14 nozzle without risk of stripping it out. 2) Right. However I've pinned the 0402 centering level down at -25um.

Homing Contact systems / versatec 3S. slow movement.

Electronics Forum | Thu Aug 08 18:21:21 EDT 2019 | Aaron

I recently purchased a contact systems 3, and 3s, and 4 of their 3zs. they were all used in various states of working. supposedly one 3s and 3z were working when taken out of service and had sat for a few months. another 3z had a homing issues and th

FS Quad 100 v3v6,Accu-Heat oven,dehart printer,quad parts

Electronics Forum | Tue Feb 24 16:57:03 EST 1998 | henry

EQUIPMENT FOR SALE QUAD 100 V3/V6 Low hours, Excellent condition, All latest factory revisions Firmware 3.65 Central controller software 5.6D with computer system Autoprogram software 5.31 1- 28" Latching feeder base 5- 4" Latching feeder b

SPM AV SCREEN PRINTER PROBLEMS

Electronics Forum | Sat May 28 19:54:20 EDT 2005 | MikeaJ

I agree with Ken, the root cause could very well be obvious. However, take a look at the following items, these checks only take a minute to accomplish. 1. If your stepper drivers are the older 5410 Pac Sci modules, check for melted power connectors

Vitronics Delta 5

Electronics Forum | Thu Jul 17 10:09:06 EDT 2008 | dfhoadle

Were dealing with firmware issues for the stepper > motor, as well as communications problems with > the software. Vitronics is looking into it... > again, but even they seemed to be stumped. You > may want to ask your rep about it. Our machine i

ultra low cost pick and place?

Electronics Forum | Sat Jun 12 19:48:47 EDT 2010 | bootstrap

I like what you're doing. 20 years ago anyone, hobbyists and tiny garage-shop companies could create electronics devices just as sophisticated and cool as big corporations. Today, SMT has largely trashed the creativity (and competition) that existe

Previous 1 2  

3 stepper searches for Companies, Equipment, Machines, Suppliers & Information