Electronics Forum | Wed Aug 06 17:45:54 EDT 2014 | rangarajd
Hello: Does any one have a soft copy of AMS 3.0 manual?
Electronics Forum | Tue Sep 19 15:11:16 EDT 2006 | d0min0
Hi there, we use inertec els 3.0 and 4.0 machines regards
Electronics Forum | Wed Sep 18 15:13:17 EDT 2002 | davef
Effects of Gold (Au) on Solder Properties Concentration Range in Weight Percentage w/o Au in Sn63/Pb37 Solder [A Sugarman/Loranger] * 2.0 - 3.0% Spreadability and fluidity of solder reduced (1) * 3.0% Highest acceptable concentration of Au in solder
Electronics Forum | Tue Nov 11 14:33:12 EST 2014 | rangarajd
Hello, I'm currently using the AMS 3.0 Build 30068 software to program my assembleon MG1R and Topaz XII's. The software is currently running on XP and would like to upgrade the OS to win 7 or 8. Is anyone successfully running a newer version of AMS
Electronics Forum | Thu Dec 16 16:28:51 EST 2004 | Indy
Hi, We are using Sn/3.0Ag/0.5Cu solder paste on Pd/Ag pad metallization in one of our application. Could someone provide me information on the following: 1. How bad is the Leaching of Ag in SAC alloy and how it can be mitigated. 2. During reflow so
Electronics Forum | Wed Jun 27 11:59:55 EDT 2007 | samir
*Preheat zone *Maximum slope is a time/temperature relationship that measures how fast the temperature on the printed circuit board changes. The ramp�up rate is usually somewhere between 1.0 �C and 3.0 �C per second, often falling between 2.0 �C and
Electronics Forum | Fri May 05 14:32:14 EDT 2000 | C.K.
I read my posting again, and it didn't sound right....what I meant was slow down your conveyor speed BY .5 to 1 FPM. So, if you're running @ 4 FPM, slow it down to 3.0 to 3.5 FPM.
Electronics Forum | Thu Feb 27 23:50:09 EST 2014 | ilatintj
I would like to speak with you. In many cases with our new COBRA 3.0....we have been able to help eliminate Steps 1-3 mils....would this be of support to you? Pls email me jv@interlatin.com.mx
Electronics Forum | Mon Apr 23 13:01:59 EDT 2001 | bdoyle
SMTnet will be down at 3:30PM EST today for maintenance. We should only be down approximately 20 minutes. We apologize for any inconvenience this might cause.
Electronics Forum | Wed Nov 08 08:12:16 EST 2006 | jnaligan
hi... try evaluating eco solder paste Sn96.5/Ag3.0/Cu0.5 from Senju... output is good and i suggest your stencil's apperture ratio with the pad 1:1 when it comes to fine pitches...and BGA pads regards, janry
